Enable the DEV_TX_OFFLOAD_MBUF_FAST_FREE in case the underlying device
supports.
This is to preserve the previous offloads configuration made according
to the PMD defaults.
Signed-off-by: Shahaf Shuler <shah...@mellanox.com>
---
app/test-pmd/testpmd.c | 8 +++++++-
1 file changed, 7 insertions(+), 1 deletion(-)
diff --git a/app/test-pmd/testpmd.c b/app/test-pmd/testpmd.c
index c1fb387fb..d6f69f5fa 100644
--- a/app/test-pmd/testpmd.c
+++ b/app/test-pmd/testpmd.c
@@ -339,7 +339,9 @@ struct rte_eth_rxmode rx_mode = {
.ignore_offload_bitfield = 1,
};
-struct rte_eth_txmode tx_mode;
+struct rte_eth_txmode tx_mode = {
+ .offloads = DEV_TX_OFFLOAD_MBUF_FAST_FREE,
+};
struct rte_fdir_conf fdir_conf = {
.mode = RTE_FDIR_MODE_NONE,
@@ -605,6 +607,10 @@ init_config(void)
port->dev_conf.txmode = tx_mode;
port->dev_conf.rxmode = rx_mode;
rte_eth_dev_info_get(pid, &port->dev_info);
+ if (!(port->dev_info.tx_offload_capa &
+ DEV_TX_OFFLOAD_MBUF_FAST_FREE))
+ port->dev_conf.txmode.offloads &=
+ ~DEV_TX_OFFLOAD_MBUF_FAST_FREE;
if (numa_support) {
if (port_numa[pid] != NUMA_NO_CONFIG)
--
2.12.0
