On Tue, 1 Aug 2017, Charles (Chas) Williams wrote:
>
>
> On 08/01/2017 07:41 PM, Shrikrishna Khare wrote:
> >
> >
> > On Mon, 24 Jul 2017, Charles (Chas) Williams wrote:
> >
> > > We should only restore shadow_vfta when hw_vlan_filter is active.
> > > Otherwise, we should restore the previous filtering behavior.
> > >
> > > Fixes: f003fc383487("vmxnet3: enable vlan filtering")
> > > Cc: sta...@dpdk.org
> > >
> > > Signed-off-by: Chas Williams <ciwil...@brocade.com>
> > > ---
> > > drivers/net/vmxnet3/vmxnet3_ethdev.c | 5 ++++-
> > > 1 file changed, 4 insertions(+), 1 deletion(-)
> > >
> > > diff --git a/drivers/net/vmxnet3/vmxnet3_ethdev.c
> > > b/drivers/net/vmxnet3/vmxnet3_ethdev.c
> > > index ab5a824..3910991 100644
> > > --- a/drivers/net/vmxnet3/vmxnet3_ethdev.c
> > > +++ b/drivers/net/vmxnet3/vmxnet3_ethdev.c
> > > @@ -1219,7 +1219,10 @@ vmxnet3_dev_promiscuous_disable(struct rte_eth_dev
> > > *dev)
> > > struct vmxnet3_hw *hw = dev->data->dev_private;
> > > uint32_t *vf_table = hw->shared->devRead.rxFilterConf.vfTable;
> > >
> > > - memcpy(vf_table, hw->shadow_vfta, VMXNET3_VFT_TABLE_SIZE);
> > > + if (dev->data->dev_conf.rxmode.hw_vlan_filter)
> > > + memcpy(vf_table, hw->shadow_vfta, VMXNET3_VFT_TABLE_SIZE);
> > > + else
> > > + memset(vf_table, 0xff, VMXNET3_VFT_TABLE_SIZE);
> >
> > From the device emulation standpoint, vf_table array set to all 1s means
> > that rx filtering is enabled but all vlan ID are allowed, while vf_table
> > array set to all 0s means that no vlan ID filtering is done.
> >
> > So, it is better to go with all 0s rather than all 1s, it is also more
> > efficient for the emulation.
> >
> > This is an existing problem in vmxnet3_dev_vlan_offload_set as well.
>
> That may be the case, but this patch isn't the place to address that.
> If this needs changed, there should be a follow on patch that makes
> this change.
Fair enough. You have my ack for this patch.
>
> >
> > > vmxnet3_dev_set_rxmode(hw, VMXNET3_RXM_PROMISC, 0);
> > > VMXNET3_WRITE_BAR1_REG(hw, VMXNET3_REG_CMD,
> > > VMXNET3_CMD_UPDATE_VLAN_FILTERS);
> > > --
> > > 2.1.4
> > >
> > >
>
