2016-12-22 11:53, Ferruh Yigit:
> To make it easy to comment to latest struct, copy-paste here:
> [With some extra notes]
>
> struct eth_dev_ops {
> eth_dev_configure_t dev_configure; /**< Configure device. */
> eth_dev_start_t dev_start; /**< Start device. */
> eth_dev_stop_t dev_stop; /**< Stop device. */
> eth_dev_set_link_up_t dev_set_link_up; /**< Device link up. */
> eth_dev_set_link_down_t dev_set_link_down; /**< Device link down. */
> eth_dev_close_t dev_close; /**< Close device. */
> eth_promiscuous_enable_t promiscuous_enable; /**< Promiscuous ON. */
> eth_promiscuous_disable_t promiscuous_disable;/**< Promiscuous OFF. */
> eth_allmulticast_enable_t allmulticast_enable;/**< RX multicast ON. */
> eth_allmulticast_disable_t allmulticast_disable;/**< RX multicast OF. */
> eth_link_update_t link_update; /**< Get device link state. */
>
> eth_stats_get_t stats_get; /**< Get generic device
> statistics. */
> eth_stats_reset_t stats_reset; /**< Reset generic device
> statistics. */
> eth_xstats_get_t xstats_get; /**< Get extended device
> statistics. */
> eth_xstats_reset_t xstats_reset; /**< Reset extended device
> statistics. */
> eth_xstats_get_names_t xstats_get_names;
> /**< Get names of extended statistics. */
> eth_queue_stats_mapping_set_t queue_stats_mapping_set;
> /**< Configure per queue stat counter mapping. */
>
> eth_dev_infos_get_t dev_infos_get; /**< Get device info. */
> eth_dev_supported_ptypes_get_t dev_supported_ptypes_get;
> /**< Get packet types supported and identified by device. */
>
> mtu_set_t mtu_set; /**< Set MTU. */
>
> vlan_filter_set_t vlan_filter_set; /**< Filter VLAN Setup. */
> vlan_tpid_set_t vlan_tpid_set; /**< Outer/Inner VLAN TPID
> Setup. */
> vlan_strip_queue_set_t vlan_strip_queue_set; /**< VLAN Stripping on
> queue. */
> vlan_offload_set_t vlan_offload_set; /**< Set VLAN Offload. */
> vlan_pvid_set_t vlan_pvid_set; /**< Set port based TX VLAN
> insertion. */
>
> eth_queue_start_t rx_queue_start;/**< Start RX for a queue. */
> eth_queue_stop_t rx_queue_stop; /**< Stop RX for a queue. */
> eth_queue_start_t tx_queue_start;/**< Start TX for a queue. */
> eth_queue_stop_t tx_queue_stop; /**< Stop TX for a queue. */
> eth_rx_queue_setup_t rx_queue_setup;/**< Set up device RX queue.
> */
> eth_queue_release_t rx_queue_release; /**< Release RX queue. */
> eth_rx_queue_count_t rx_queue_count;/**< Get Rx queue count. */
> eth_rx_descriptor_done_t rx_descriptor_done; /**< Check rxd DD bit. */
> eth_rx_enable_intr_t rx_queue_intr_enable; /**< Enable Rx queue
> interrupt. */
> eth_rx_disable_intr_t rx_queue_intr_disable; /**< Disable Rx queue
> interrupt. */
> eth_tx_queue_setup_t tx_queue_setup;/**< Set up device TX queue.
> */
> eth_queue_release_t tx_queue_release; /**< Release TX queue. */
>
> eth_dev_led_on_t dev_led_on; /**< Turn on LED. */ [Really
> need these comments?]
> eth_dev_led_off_t dev_led_off; /**< Turn off LED. */
>
> flow_ctrl_get_t flow_ctrl_get; /**< Get flow control. */
> flow_ctrl_set_t flow_ctrl_set; /**< Setup flow control. */
> priority_flow_ctrl_set_t priority_flow_ctrl_set; /**< Setup priority
> flow control. */
>
> eth_mac_addr_remove_t mac_addr_remove; /**< Remove MAC address. */
> eth_mac_addr_add_t mac_addr_add; /**< Add a MAC address. */
> eth_mac_addr_set_t mac_addr_set; /**< Set a MAC address. */
> eth_set_mc_addr_list_t set_mc_addr_list; /**< set list of mcast
> addrs. */
Could we group the MAC functions with promiscuous and allmulticast?
> eth_uc_hash_table_set_t uc_hash_table_set; /**< Set Unicast Table
> Array. */
> eth_uc_all_hash_table_set_t uc_all_hash_table_set; /**< Set Unicast
> hash bitmap. */
>
> eth_mirror_rule_set_t mirror_rule_set; /**< Add a traffic mirror
> rule. */
> eth_mirror_rule_reset_t mirror_rule_reset; /**< reset a traffic
> mirror rule. */
>
> [Following already removed from next-net]
> eth_set_vf_rx_mode_t set_vf_rx_mode;/**< Set VF RX mode. */
> eth_set_vf_rx_t set_vf_rx; /**< enable/disable a VF
> receive. */
> eth_set_vf_tx_t set_vf_tx; /**< enable/disable a VF
> transmit. */
> eth_set_vf_vlan_filter_t set_vf_vlan_filter; /**< Set VF VLAN filter.
> */
> eth_set_vf_rate_limit_t set_vf_rate_limit; /**< Set VF rate limit. */
>
> eth_udp_tunnel_port_add_t udp_tunnel_port_add; /** Add UDP tunnel
> port. */
> eth_udp_tunnel_port_del_t udp_tunnel_port_del; /** Del UDP tunnel
> port. */
>
> eth_set_queue_rate_limit_t set_queue_rate_limit; /**< Set queue rate
> limit. */
>
> rss_hash_update_t rss_hash_update; /** Configure RSS hash
> protocols. */
> rss_hash_conf_get_t rss_hash_conf_get; /** Get current RSS hash
> configuration. */
> reta_update_t reta_update; /** Update redirection table.
> */
> reta_query_t reta_query; /** Query redirection table.
> */
>
> eth_get_reg_t get_reg; /**< Get registers. */
> eth_get_eeprom_length_t get_eeprom_length; /**< Get eeprom length. */
> eth_get_eeprom_t get_eeprom; /**< Get eeprom data. */
> eth_set_eeprom_t set_eeprom; /**< Set eeprom. */
>
> /* bypass control */
> bypass_init_t bypass_init;
> bypass_state_set_t bypass_state_set;
> bypass_state_show_t bypass_state_show;
> bypass_event_set_t bypass_event_set;
> bypass_event_show_t bypass_event_show;
> bypass_wd_timeout_set_t bypass_wd_timeout_set;
> bypass_wd_timeout_show_t bypass_wd_timeout_show;
> bypass_ver_show_t bypass_ver_show;
> bypass_wd_reset_t bypass_wd_reset;
>
> eth_filter_ctrl_t filter_ctrl; /**< common filter control. */
>
> eth_rxq_info_get_t rxq_info_get; /**< retrieve RX queue
> information. */
> eth_txq_info_get_t txq_info_get; /**< retrieve TX queue
> information. */
It can be grouped with dev_infos_get
> eth_get_dcb_info get_dcb_info; /** Get DCB information. */
>
> eth_timesync_enable_t timesync_enable;
> /** Turn IEEE1588/802.1AS timestamping on. */
> eth_timesync_disable_t timesync_disable;
> /** Turn IEEE1588/802.1AS timestamping off. */
> eth_timesync_read_rx_timestamp_t timesync_read_rx_timestamp;
> /** Read the IEEE1588/802.1AS RX timestamp. */
> eth_timesync_read_tx_timestamp_t timesync_read_tx_timestamp;
> /** Read the IEEE1588/802.1AS TX timestamp. */
> eth_timesync_adjust_time timesync_adjust_time; /** Adjust the device
> clock. */
> eth_timesync_read_time timesync_read_time; /** Get the device clock
> time. */
> eth_timesync_write_time timesync_write_time; /** Set the device
> clock time. */
>
> eth_l2_tunnel_eth_type_conf_t l2_tunnel_eth_type_conf;
> /** Config ether type of l2 tunnel. */
> eth_l2_tunnel_offload_set_t l2_tunnel_offload_set;
> /** Enable/disable l2 tunnel offload functions. */
May it be grouped with other tunnel functions?
> };
