Remove the dev_started check in nbl_mtu_set() to allow MTU
configuration while the port is started.
Fixes: 75cdda36a4c5 ("net/nbl: support MTU update")
Cc: [email protected]
Signed-off-by: Dimon Zhao <[email protected]>
---
drivers/net/nbl/nbl_dev/nbl_dev.c | 6 ------
1 file changed, 6 deletions(-)
diff --git a/drivers/net/nbl/nbl_dev/nbl_dev.c
b/drivers/net/nbl/nbl_dev/nbl_dev.c
index 320f26619f..1c04fb8bfd 100644
--- a/drivers/net/nbl/nbl_dev/nbl_dev.c
+++ b/drivers/net/nbl/nbl_dev/nbl_dev.c
@@ -760,12 +760,6 @@ int nbl_mtu_set(struct rte_eth_dev *eth_dev, uint16_t mtu)
uint32_t frame_size = mtu + NBL_ETH_OVERHEAD;
int ret;
- /* mtu setting is forbidden if port is start */
- if (dev_data->dev_started) {
- NBL_LOG(ERR, "port %d must be stopped before configuration",
dev_data->port_id);
- return -EBUSY;
- }
-
dev_data->dev_conf.rxmode.mtu = frame_size;
ret = disp_ops->set_mtu(NBL_DEV_MGT_TO_DISP_PRIV(dev_mgt),
dev_mgt->net_dev->vsi_id, mtu);
if (ret)
--
2.34.1
