From: Jeremy Spewock <jspew...@iol.unh.edu>
There are methods within DTS currently that support updating the MTU of
ports on a node, but the methods for doing this in a linux session rely
on the ip command and the port being bound to the kernel driver. Since
test suites are run while bound to the driver for DPDK, there needs to
be a way to modify the value while bound to said driver as well. This is
done by using testpmd to modify the MTU.
Depends-on: patch-142952 ("dts: add ability to start/stop testpmd
ports")
Signed-off-by: Jeremy Spewock <jspew...@iol.unh.edu>
---
dts/framework/remote_session/testpmd_shell.py | 27 +++++++++++++++++++
1 file changed, 27 insertions(+)
diff --git a/dts/framework/remote_session/testpmd_shell.py
b/dts/framework/remote_session/testpmd_shell.py
index ca24b28070..0d2c972b8f 100644
--- a/dts/framework/remote_session/testpmd_shell.py
+++ b/dts/framework/remote_session/testpmd_shell.py
@@ -888,6 +888,33 @@ def show_port_stats(self, port_id: int) ->
TestPmdPortStats:
return TestPmdPortStats.parse(output)
+ @requires_stopped_ports
+ def set_port_mtu(self, port_id: int, mtu: int, verify: bool = True) ->
None:
+ """Change the MTU of a port using testpmd.
+
+ Some PMDs require that the port be stopped before changing the MTU,
and it does no harm to
+ stop the port before configuring in cases where it isn't required, so
we first stop ports,
+ then update the MTU, then start the ports again afterwards.
+
+ Args:
+ port_id: ID of the port to adjust the MTU on.
+ mtu: Desired value for the MTU to be set to.
+ verify: If `verify` is :data:`True` then the output will be
scanned in an attempt to
+ verify that the mtu was properly set on the port. Defaults to
:data:`True`.
+
+ Raises:
+ InteractiveCommandExecutionError: If `verify` is :data:`True` and
the MTU was not
+ properly updated on the port matching `port_id`.
+ """
+ set_mtu_output = self.send_command(f"port config mtu {port_id} {mtu}")
+ if verify and (f"MTU: {mtu}" not in self.send_command(f"show port info
{port_id}")):
+ self._logger.debug(
+ f"Failed to set mtu to {mtu} on port {port_id}." f" Output
was:\n{set_mtu_output}"
+ )
+ raise InteractiveCommandExecutionError(
+ f"Test pmd failed to update mtu of port {port_id} to {mtu}"
+ )
+
def _close(self) -> None:
"""Overrides :meth:`~.interactive_shell.close`."""
self.stop()
--
2.46.0
