On 2/27/23 10:04, Maxime Coquelin wrote:
On 2/24/23 19:20, Nicolas Chautru wrote:
Cosmetic change to refer explictly to the full name of the PMD
Fixed explictly -> explicitly
Intel vRAN Boost v1.
VRB1 acronym is only used as a prefix within the code.
Signed-off-by: Nicolas Chautru <nicolas.chau...@intel.com>
---
doc/guides/bbdevs/vrb1.rst | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/doc/guides/bbdevs/vrb1.rst b/doc/guides/bbdevs/vrb1.rst
index f5a9dff804..9c48d30964 100644
--- a/doc/guides/bbdevs/vrb1.rst
+++ b/doc/guides/bbdevs/vrb1.rst
@@ -104,7 +104,7 @@ Initialization
--------------
When the device first powers up, its PCI Physical Functions (PF)
-can be listed through these commands for VRB1:
+can be listed through these commands for Intel vRAN Boost v1:
.. code-block:: console
@@ -123,7 +123,7 @@ Install the DPDK igb_uio driver, bind it with the
PF PCI device ID and use
``lspci`` to confirm the PF device is under use by ``igb_uio`` DPDK
UIO driver.
The igb_uio driver may be bound to the PF PCI device using one of
two methods
-for VRB1:
+for Intel vRAN Boost v1:
#. PCI functions (physical or virtual, depending on the use case)
can be bound
to the UIO driver by repeating this command for every function.
@@ -252,7 +252,7 @@ from the VF and not only limited to the PF as
captured above.
See for more details: https://github.com/intel/pf-bb-config
-Specifically for the bbdev VRB1 PMD, the command below can be used
+Specifically for the bbdev Intel vRAN Boost v1 PMD, the command below
can be used
(note that ACC200 was used previously to refer to VRB1):
.. code-block:: console
Reviewed-by: Maxime Coquelin <maxime.coque...@redhat.com>
Thanks,
Maxime
Applied to dpdk-next-baseband/for-main.
Thanks,
Maxime
