Thanks for the reply. Actually till this time the test has not even started. I have a INTEL processor with 2 onboard nic. b5:00.0 Ethernet controller: Intel Corporation Ethernet Connection X722 for 10GbE backplane (rev 04) b5:00.1 Ethernet controller: Intel Corporation Ethernet Connection X722 for 10GbE backplane (rev 04)
I created 2 VF on each of the PF and whitelisted the VF's PCI to execute my test app. I am using one VF from each to create a bond(ACTIVE BACKUP) that will be used by my app. EAL init is fine after that port configure is fine as of now. But after bond creation when I am going for init, it gives me this error mac_address_slaves_update(1495) - 1 Failed to update port Id 0 MAC address and furter on port start fails. Thanks. Regards, Nishant Verma On Fri, Sep 17, 2021 at 8:51 PM Min Hu (Connor) <humi...@huawei.com> wrote: > Hi, Nishant, > could you tell us your complete detailed steps and logs for test ？ > the more detailed the better， thanks. > > 在 2021/9/18 1:20, Nishant Verma 写道: > > Hi, > > > > I am stuck with a bonding issue wrt. DPDK 18.11 with X722 ethernet > > controller. > > > > My system basically creates VF's through SRIOV on top of two PF's. One > > issue I found was if I try to change the MAC address of VF more then > once, > > it won't let me do that. Anyway I can live with that but when I am > creating > > bond interface on top of 2 VF's. I am getting this error. > > > > Changed Address:06:00:00:02:b7:21 > > FWK: Bond interface net_bonding1 created successfully, id = 2 > > > > *mac_address_slaves_update(1495) - Failed to update port Id 0 MAC > address*FWK: > > Adding slave (0) to bond (2) > > mac_address_slaves_update(1495) - Failed to update port Id 0 MAC address > > mac_address_slaves_update(1503) - Failed to update port Id 1 MAC address > > FWK: Adding slave (1) to bond (2) > > mac_address_slaves_update(1495) - Failed to update port Id 0 MAC address > > mac_address_slaves_update(1503) - Failed to update port Id 1 MAC address > > EAL: Error - exiting with code: 1 > > Cause: rte_eth_dev_start: err=-1, port=2 > > > > I checked a whole lot of patches but everything seems to be in place in > > this release. What else can I try to get rid of these errors? > > > > Thanks. > > > > Regards, > > Nishant Verma > > . > > >
