After DCB mode is configured, if we decrease the number of RX and TX
queues, fwd_config_setup() will be called to setup the DCB forwarding
configuration. And forwarding streams are updated based on new queue
numbers in fwd_config_setup(), but the mapping between the TC and
queues obtained by rte_eth_dev_get_dcb_info() is still old queue
numbers (old queue numbers are greater than new queue numbers).
In this case, the segment fault happens. So rte_eth_dev_configure()
should be called again to update the mapping between the TC and
queues before rte_eth_dev_get_dcb_info().
Like:
set nbcore 4
port stop all
port config 0 dcb vt off 4 pfc on
port start all
port stop all
port config all rxq 8
port config all txq 8
Fixes: 900550de04a7 ("app/testpmd: add dcb support")
Cc: sta...@dpdk.org
Signed-off-by: Huisong Li <lihuis...@huawei.com>
Signed-off-by: Lijun Ou <ouli...@huawei.com>
---
app/test-pmd/config.c | 26 ++++++++++++++++++++++++++
1 file changed, 26 insertions(+)
diff --git a/app/test-pmd/config.c b/app/test-pmd/config.c
index 03ee40c..18b197b 100644
--- a/app/test-pmd/config.c
+++ b/app/test-pmd/config.c
@@ -2996,7 +2996,33 @@ dcb_fwd_config_setup(void)
uint16_t nb_rx_queue, nb_tx_queue;
uint16_t i, j, k, sm_id = 0;
uint16_t total_tc_num;
+ struct rte_port *port;
uint8_t tc = 0;
+ portid_t pid;
+ int ret;
+
+ /*
+ * The fwd_config_setup() is called when the port is RTE_PORT_STARTED
+ * RTE_PORT_STOPPED. When a port is RTE_PORT_STARTED, dev_configure
+ * cannot be called.
+ *
+ * re-configure the device after changing queue numbers of stopped
+ * ports, so that the updated mapping between tc and queue can be
+ * obtained.
+ */
+ for (pid = 0; pid < nb_fwd_ports; pid++) {
+ if (port_is_started(pid) == 1)
+ continue;
+
+ port = &ports[pid];
+ ret = rte_eth_dev_configure(pid, nb_rxq, nb_txq,
+ &port->dev_conf);
+ if (ret < 0) {
+ printf("Failed to re-configure port %d, ret = %d.\n",
+ pid, ret);
+ return;
+ }
+ }
cur_fwd_config.nb_fwd_lcores = (lcoreid_t) nb_fwd_lcores;
cur_fwd_config.nb_fwd_ports = nb_fwd_ports;
--
2.7.4
