[dpdk-dev] [PATCH v1 29/38] net/mvpp2: autoneg disable handling

[lironh]

From: Yuri Chipchev <yu...@marvell.com>

flow control autoneg disable is not supported

Signed-off-by: Yuri Chipchev <yu...@marvell.com>
Reviewed-by: Liron Himi <lir...@marvell.com>
---
 drivers/net/mvpp2/mrvl_ethdev.c | 9 +++++++--
 1 file changed, 7 insertions(+), 2 deletions(-)

diff --git a/drivers/net/mvpp2/mrvl_ethdev.c b/drivers/net/mvpp2/mrvl_ethdev.c
index 66c3c8e57..535d7cc60 100644
--- a/drivers/net/mvpp2/mrvl_ethdev.c
+++ b/drivers/net/mvpp2/mrvl_ethdev.c
@@ -2135,6 +2135,7 @@ mrvl_flow_ctrl_get(struct rte_eth_dev *dev, struct 
rte_eth_fc_conf *fc_conf)
        if (!priv)
                return -EPERM;
 
+       fc_conf->autoneg = 1;
        ret = pp2_ppio_get_rx_pause(priv->ppio, &en);
        if (ret) {
                MRVL_LOG(ERR, "Failed to read rx pause state");
@@ -2184,13 +2185,17 @@ mrvl_flow_ctrl_set(struct rte_eth_dev *dev, struct 
rte_eth_fc_conf *fc_conf)
        if (fc_conf->high_water ||
            fc_conf->low_water ||
            fc_conf->pause_time ||
-           fc_conf->mac_ctrl_frame_fwd ||
-           fc_conf->autoneg) {
+           fc_conf->mac_ctrl_frame_fwd) {
                MRVL_LOG(ERR, "Flowctrl parameter is not supported");
 
                return -EINVAL;
        }
 
+       if (fc_conf->autoneg == 0) {
+               MRVL_LOG(ERR, "Flowctrl Autoneg disable is not supported");
+               return -EINVAL;
+       }
+
        switch (fc_conf->mode) {
        case RTE_FC_FULL:
                rx_en = 1;
-- 
2.28.0