[dpdk-dev] [PATCH v3 02/19] net/ixgbe/base: change flow for "Apply Update" command

[Guinan Sun]

For the "Apply Update" command the firmware does not
given an response. For this command, success should
be return.

Signed-off-by: Mateusz Kowalski <mateusz.kowal...@intel.com>
Signed-off-by: Guinan Sun <guinanx....@intel.com>
Reviewed-by: Wei Zhao <wei.zh...@intel.com>
---
 drivers/net/ixgbe/base/ixgbe_common.c | 9 ++++++++-
 1 file changed, 8 insertions(+), 1 deletion(-)

diff --git a/drivers/net/ixgbe/base/ixgbe_common.c 
b/drivers/net/ixgbe/base/ixgbe_common.c
index 5889410f9..fec6241f5 100644
--- a/drivers/net/ixgbe/base/ixgbe_common.c
+++ b/drivers/net/ixgbe/base/ixgbe_common.c
@@ -4528,11 +4528,18 @@ s32 ixgbe_hic_unlocked(struct ixgbe_hw *hw, u32 
*buffer, u32 length,
                msec_delay(1);
        }
 
+       /* For each command except "Apply Update" perform
+        * status checks in the HICR registry.
+        */
+       if ((buffer[0] & IXGBE_HOST_INTERFACE_MASK_CMD) ==
+           IXGBE_HOST_INTERFACE_APPLY_UPDATE_CMD)
+               return IXGBE_SUCCESS;
+
        /* Check command completion */
        if ((timeout && i == timeout) ||
            !(IXGBE_READ_REG(hw, IXGBE_HICR) & IXGBE_HICR_SV)) {
                ERROR_REPORT1(IXGBE_ERROR_CAUTION,
-                            "Command has failed with no status valid.\n");
+                             "Command has failed with no status valid.\n");
                return IXGBE_ERR_HOST_INTERFACE_COMMAND;
        }
 
-- 
2.17.1