Hi Thomas,
Thanks very much for your reminder, you give me many help in this mail list.
The issue with detailed information just as below. but I don't know
who is the dpdk i40e maintainers? is maintainers at dpdk.org?
Hardware list:
2 i40e 40G NICs
Xeon E5-2670 v2(10 cores)
32G memory
I loopback 2 i40e NICs by QSFP cable, one NIC send UDP network packet by
DPDK,
and another for receiving. I bind 4 processor's logical cores with 4 rx
queue
"0,1,2,3" on receiving NIC, when I start to send packet, only rx queue "0"
can receive
the UDP packet, the others queue always receive nothing. but it is work well
on ixgbe
10G NICs, I can receive network packet from all rx queues. does anyone
kindly know why?
Regards,
Haifeng
-----Original Message-----
From: Thomas Monjalon [mailto:thomas.monja...@6wind.com]
Sent: Friday, February 27, 2015 6:55 PM
To: lhffjzh
Cc: dev at dpdk.org
Subject: Re: Why only rx queue "0" can receive network packet by i40e NIC
2015-02-27 16:47, lhffjzh:
> Hi All,
>
> We use 4 cores loop 4 rx queues on one i40e port, but only rx queue "0"
can
> receive network packet, do anyone kindly know why? BTW, all of network
> packet has same destination ip address but has more than 200 different
> source ip address.
It's possible that you don't have any answer for 2 reasons:
- you replied in a thread dedicated to Cisco enic questions
- you didn't describe your usage enough to understand your problem
I suggest to use the button "new email" instead of "reply all" to
start a new question with enough details.
Did you noticed you put some Cisco guys in CC instead of putting the
Intel responsible for i40e (see MAINTAINERS file)?
