From: Kiran Kumar K <kirankum...@marvell.com> If HIGIG mode is enabled on configure, This needs to be disabled on port stop. Adding support to send mbox message on port stop to configure the port to default.
Signed-off-by: Kiran Kumar K <kirankum...@marvell.com> --- drivers/net/octeontx2/otx2_ethdev.c | 9 +++++++-- 1 file changed, 7 insertions(+), 2 deletions(-) diff --git a/drivers/net/octeontx2/otx2_ethdev.c b/drivers/net/octeontx2/otx2_ethdev.c index 268b383db..11f8c786b 100644 --- a/drivers/net/octeontx2/otx2_ethdev.c +++ b/drivers/net/octeontx2/otx2_ethdev.c @@ -93,7 +93,7 @@ nix_lf_alloc(struct otx2_eth_dev *dev, uint32_t nb_rxq, uint32_t nb_txq) } static int -nix_lf_switch_header_type_enable(struct otx2_eth_dev *dev) +nix_lf_switch_header_type_enable(struct otx2_eth_dev *dev, bool enable) { struct otx2_mbox *mbox = dev->mbox; struct npc_set_pkind *req; @@ -106,12 +106,16 @@ nix_lf_switch_header_type_enable(struct otx2_eth_dev *dev) /* Notify AF about higig2 config */ req = otx2_mbox_alloc_msg_npc_set_pkind(mbox); req->mode = dev->npc_flow.switch_header_type; + if (enable == 0) + req->mode = OTX2_PRIV_FLAGS_DEFAULT; req->dir = PKIND_RX; rc = otx2_mbox_process_msg(mbox, (void *)&rsp); if (rc) return rc; req = otx2_mbox_alloc_msg_npc_set_pkind(mbox); req->mode = dev->npc_flow.switch_header_type; + if (enable == 0) + req->mode = OTX2_PRIV_FLAGS_DEFAULT; req->dir = PKIND_TX; return otx2_mbox_process_msg(mbox, (void *)&rsp); } @@ -1648,7 +1652,7 @@ otx2_nix_configure(struct rte_eth_dev *eth_dev) goto free_nix_lf; } - rc = nix_lf_switch_header_type_enable(dev); + rc = nix_lf_switch_header_type_enable(dev, true); if (rc) { otx2_err("Failed to enable switch type nix_lf rc=%d", rc); goto free_nix_lf; @@ -1882,6 +1886,7 @@ otx2_nix_dev_stop(struct rte_eth_dev *eth_dev) struct otx2_eth_rxq *rxq; int count, i, j, rc; + nix_lf_switch_header_type_enable(dev, false); nix_cgx_stop_link_event(dev); npc_rx_disable(dev); -- 2.17.1