On 7/17/2019 8:45 AM, viveksha...@marvell.com wrote: > From: Vivek Sharma <viveksha...@marvell.com> > > Support QinQ strip RX offload configuration through > testpmd command line and boot time arguments.
For the testpmd command part, unfortunately there are two set of commands for same purpose, the new ones are (lets both port and queue level): "port config <port_id> rx_offload ..." "port (port_id) rxq (queue_id) rx_offload ..." "port config (port_id) tx_offload ..." "port (port_id) txq (queue_id) tx_offload ..." These are better implementation comparing the old one: "port config all ..." Would you mind sending a patch to remove "port config all ..." variant of setting offloads? And you can make your changes to the new commands above. For the application argument, ``--enable-hw-vlan-extend``, instead of adding a parameter of each offload argument, (and event it is not clear if it is only for Rx or Tx), have a "--rx-offloads" argument and feed the list via this, like: "--rx-ofloads=disable-crc-strip,enable-rx-timestamp" And lastly for the "vlan set ..." update, I think "qinq" was already defined but it was calling 'vlan_extend_set()', now you are changing it and making it call 'rx_vlan_qinq_strip_set()', I think this is OK, but can you please update the 'cmd_help_long_parsed()' accordingly? And in original 'cmd_help_long_parsed()' for 'vlan set ...", it doesn't need to have separate lines for "strip, filter & qinq", can you please merge them, and later the 'extend' one? Than change needs to be documented on "testpmd_funcs.rst" And as a last thing, can you please send this as multiple patches: 1) Command line change for setting qinq offload 2) Application argument change 3) "vlan set " related changes > > Signed-off-by: Vivek Sharma <viveksha...@marvell.com>
