Hi, Xiaoyu
There is a couple of small points to note:
1) It would be good to have the testpmd flow create command sample with new
tunnels in commit log.
2) is it OK: "mlx5_flow_tunnel_ip_check(items, &last_item); " ?
It looks like a bug, should the second parameter be "&item_flags" ? (if so
- please, fix all
calls of mlx5_flow_tunnel_ip_check())
WBR,
Slava
> -----Original Message-----
> From: Xiaoyu Min <jack...@mellanox.com>
> Sent: Wednesday, July 10, 2019 13:15
> To: Raslan Darawsheh <rasl...@mellanox.com>; Slava Ovsiienko
> <viachesl...@mellanox.com>; Shahaf Shuler <shah...@mellanox.com>;
> Yongseok Koh <ys...@mellanox.com>; John McNamara
> <john.mcnam...@intel.com>; Marko Kovacevic
> <marko.kovace...@intel.com>
> Cc: dev@dpdk.org
> Subject: [Suspected-Phishing][PATCH v3] net/mlx5: support IP-in-IP tunnel
>
> Enabled IP-in-IP tunnel type support on DV/DR flow engine.
> This includes the following combination:
> - IPv4 over IPv4
> - IPv4 over IPv6
> - IPv6 over IPv4
> - IPv6 over IPv6
>
> MLX5 NIC supports IP-in-IP tunnel via FLEX Parser so need to make sure fw
> using FLEX Paser profile 0.
>
> mlxconfig -d <mst device> -y set FLEX_PARSER_PROFILE_ENABLE=0
>
> Signed-off-by: Xiaoyu Min <jack...@mellanox.com>
> ---
> v2:
> * updated release note
> v3:
> * rebased on 19.08-rc1
> ---
> doc/guides/nics/mlx5.rst | 15 ++++++++++-
> doc/guides/rel_notes/release_19_08.rst | 1 +
> drivers/net/mlx5/mlx5_flow.c | 35 ++++++++++++++++++++++++
> drivers/net/mlx5/mlx5_flow.h | 6 ++++-
> drivers/net/mlx5/mlx5_flow_dv.c | 37 ++++++++++++++++++++++++++
> 5 files changed, 92 insertions(+), 2 deletions(-)
>
