Hello Thomas,
On 05/21/2018 10:39 AM, Thomas Monjalon wrote:
21/05/2018 05:35, Zijie Pan:
Add a new API rte_pmd_i40e_set_lldp_cmd to control LLDP agent for i40e.
It supports the following i40e debug lldp commands:
- start/stop of the LLDP agent.
- get local/remote of the LLDP MIB (Management Information Base).
Signed-off-by: Laurent Hardy <laurent.ha...@6wind.com>
Signed-off-by: Zijie Pan <zijie....@6wind.com>
Does it mean that this feature is enabled by default in i40e devices?
Should it be disabled by default?
The new API is just an interface to control the LLDP agent. No functions of
i40e call it by default. It is only used to debug LLDP of i40e devices. For
example we can add a new command for test-pmd to debug lldp of i40e by calling
rte_pmd_i40e_set_lldp_cmd().
There is a command to stop the LLDP agent.
My question is to know whether this agent is running by default
and should be disabled?
This agent is running by default.
Beside, disabling LLDP agent when using old fw (NVM 4.53 or 5.x) could
have some side effects.
https://www.intel.com/content/dam/www/public/us/en/documents/specification-updates/xl710-10-40-controller-spec-update.pdf
Extracted from x710 intel spec:
"70. LLDP Disable Can Result in Incorrect Configuration of the Receive Packet
Buffer
Problem:
---------
The default operation of the device is LLDP enabled.
LLDP can be disabled by an AQ command or by a custom NVM obtained from Intel.
Disabling LLDP when using NVM 4.53 or 5.x can result in the device firmware not
configuring the Receive Packet Buffer according to the link mode and flow
control settings.
Implication:
------------
If flow control is disabled, a hang of the receive data path could occur
wherein all received packets are dropped.
If flow control is enabled, the incorrect settings could cause packet drops
despite the flow control, making the flow control ineffective.
Also, throughput might be sub-optimal in some cases.
Workaround:
-----------
When using NVM 4.53 or 5.x, do one of the following:
• Do not disable LLDP or DCBx. Leave the device in default operation mode.
• Use the Set Local LLDP MIB admin queue command to apply the (default) DCB
configuration during driver initialization and following any link-up event.
When using NVM 6.01 or later, the receive data path does not hang even if the FW
LLDP is disabled."
I mean i40e is generating LLDP packets by default?
