Hi, If you are not using SRIOV or direct device assignment to VM, your traffic hits vSwitch(via vmware native ixgbe driver and network stack) in the ESX and switched to your E1000/VMXNET3 interface connected to a VM. The vSwitch is not optimized for PMD at present so you would get optimal performance benefit having PMD, I believe.
For the RSS front, I would say you won't see much difference with RSS enabled for 1500 bytes frames. In fact, core is capable of handling such traffic in VM, but the bottleneck is in ESXi software switching layer, that's what my initial research shows across multiple hypervisors. Thanks, Rashmin -----Original Message----- From: dev [mailto:dev-boun...@dpdk.org] On Behalf Of Selvaganapathy Chidambaram Sent: Thursday, October 03, 2013 2:39 PM To: dev at dpdk.org Subject: [dpdk-dev] L2fwd Performance issue with Virtual Machine Hello Everyone, I have tried to run DPDK sample application l2fwd(modified to support multiple queues) in my ESX Virtual Machine. I see that performance is not scaling with cores. [My apologies for the long email] *Setup:* Connected VM to two ports of Spirent with 10Gig link. Sent 10 Gig traffic of L3 packet of length 1500 bytes (with four different flows) from Spirent through one port and received at the second port. Also sent traffic from reverse direction so that net traffic is 20 Gbps. Haven't enabled SR-IOV or Direct path I/O. *Emulated Driver:* With default emulated driver, I got 7.3 Gbps for 1 core. Adding multiple cores did not improve the performance. On debugging I noticed that function eth_em_infos_get() says RSS is not supported. *vmxnet3_usermap:* Then I tried extension vmxnet3_usermap and got 8.7 Gbps for 1 core. Again adding another core did not help. On debugging, I noticed that in vmxnet3 kernel driver (in function vmxnet3_probe_device) , RSS is disabled if * adapter->is_shm* is non zero. In our case, its adapter->VMXNET3_SHM_USERMAP_DRIVER which is non zero. Before trying to enable it, I would like to know if there is any known limitation why RSS is not enabled in both the drivers. Please help me understand. *Hardware Configuration:* Hardware : Intel Xeon 2.4 Ghz 4 CPUs Hyperthreading : No RAM : 16 GB Hypervisor : ESXi 5.1 Ethernet : Intel 82599EB 10 Gig SFP Guest VM : 2 vCPU, 2 GB RAM GuestOS : Centos 6.2 32 bit Thanks in advance for your time and help!!! Thanks, Selva.
