Before opening a BugZilla issue, I'll post what I'm seing: I have a 'recursing' build file (build.xml), that imports recurse.xml to do the actual recursing (build.xml just specify which subdirs to recurse into), and the build file I'm recursing into (rescue.xml) fails to parse correctly for good reasons (because using a custom URL protocol no longer defined). Look at the error message below:
P:\com_lgc\10.0.7\gocad\T-Surf\Filters>build -Dmsdev=false Buildfile: P:\com_lgc\10.0.7\gocad\T-Surf\Filters\build.xml BUILD FAILED P:\com_lgc\10.0.7\gocad\config\recurse.xml:40: Error reading project file: unknown protocol: resource Total time: 2 seconds The error message doesn't specify which build file failed to parse correctly, and furthermore, the error is reported to occur in recurse.xml, never mentioning that recurse.xml was in fact imported from build.xml or at which line. Add a level or two of importing and/or one or two ant/antcall/subant layer, and it quickly becomes a real headache to troubleshoot a problem. Even in this simple case, I was confused, when I'm the writers of all the build files. Had to resort to -debug scrutinizing to figure it out, even that is not easy at all. The debug out somehow shows the same references being set several times, reports about imported build files several times, etc... I *really* hope we would somehow improve on this situation before Ant 1.6 release. October 30 sounds like a hasty release date. --DD --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
