The branch main has been updated by adrian:
URL:
https://cgit.FreeBSD.org/src/commit/?id=f858e9281c60d0730ab20ed94eef5c52e66795ee
commit f858e9281c60d0730ab20ed94eef5c52e66795ee
Author: Adrian Chadd <adr...@freebsd.org>
AuthorDate: 2021-05-22 23:39:16 +0000
Commit: Adrian Chadd <adr...@freebsd.org>
CommitDate: 2021-05-22 23:39:16 +0000
[ath] Handle STA + AP beacon programming without stomping over HW AP beacon
programming
I've been using STA+AP modes at home for a couple years now
and I've been finding and fixing a lot of weird corner cases.
This is the eventual patchset I've landed on.
* Don't force beacon resync in STA mode if we're using sw beacon tracking.
This stops a variety of stomping issues when the STA VAP is reconfigured;
the AP hardware beacons were being stomped on!
* Use the first AP VAP to configure beacons on, rather than the first VAP.
This prevents weird behaviour in ath_beacon_config() when the hardware
is being reconfigured and the STA VAP was the first one created.
* Ensure the beacon interval / timing programming is within the AR9300
HAL bounds by masking off any flags that may have been there before
shifting the value up to 1/8 TUs rather than the 1 TU resolution the
previous chips used.
Now I don't get weird beacon reprogramming during startup, STA state
changes and hardware recovery which showed up as HI-LARIOUS beacon
configurations and STAs that would just disconnect from the AP very
frequently.
Tested:
* AR9344/AR9380, STA and AP and STA+AP modes
---
sys/dev/ath/if_ath.c | 34 ++++++++++++++++++++------------
sys/dev/ath/if_ath_beacon.c | 48 +++++++++++++++++++++++++++++++++++----------
sys/dev/ath/if_ath_rx.c | 1 +
3 files changed, 61 insertions(+), 22 deletions(-)
diff --git a/sys/dev/ath/if_ath.c b/sys/dev/ath/if_ath.c
index 698b8d1a2853..4bc5c31812e7 100644
--- a/sys/dev/ath/if_ath.c
+++ b/sys/dev/ath/if_ath.c
@@ -2450,13 +2450,15 @@ ath_bmiss_vap(struct ieee80211vap *vap)
ath_power_setpower(sc, HAL_PM_AWAKE, 0);
ath_power_restore_power_state(sc);
ATH_UNLOCK(sc);
+
DPRINTF(sc, ATH_DEBUG_BEACON,
"%s: forced awake; force syncbeacon=1\n", __func__);
-
- /*
- * Attempt to force a beacon resync.
- */
- sc->sc_syncbeacon = 1;
+ if ((vap->iv_flags_ext & IEEE80211_FEXT_SWBMISS) == 0) {
+ /*
+ * Attempt to force a beacon resync.
+ */
+ sc->sc_syncbeacon = 1;
+ }
ATH_VAP(vap)->av_bmiss(vap);
}
@@ -6061,19 +6063,25 @@ ath_newstate(struct ieee80211vap *vap, enum
ieee80211_state nstate, int arg)
* In that case, we may not receive an actual
* beacon to update the beacon timer and thus we
* won't get notified of the missing beacons.
+ *
+ * Also, don't do any of this if we're not running
+ * with hardware beacon support, as that'll interfere
+ * with an AP VAP.
*/
if (ostate != IEEE80211_S_RUN &&
ostate != IEEE80211_S_SLEEP) {
- DPRINTF(sc, ATH_DEBUG_BEACON,
- "%s: STA; syncbeacon=1\n", __func__);
- sc->sc_syncbeacon = 1;
+
+ if ((vap->iv_flags_ext &
IEEE80211_FEXT_SWBMISS) == 0) {
+ DPRINTF(sc, ATH_DEBUG_BEACON,
+ "%s: STA; syncbeacon=1\n",
__func__);
+ sc->sc_syncbeacon = 1;
+ if (csa_run_transition)
+ ath_beacon_config(sc, vap);
+ }
/* Quiet time handling - ensure we resync */
memset(&avp->quiet_ie, 0,
sizeof(avp->quiet_ie));
- if (csa_run_transition)
- ath_beacon_config(sc, vap);
-
/*
* PR: kern/175227
*
@@ -6086,7 +6094,9 @@ ath_newstate(struct ieee80211vap *vap, enum
ieee80211_state nstate, int arg)
* timer fires (too often), leading to a STA
* disassociation.
*/
- sc->sc_beacons = 1;
+ if ((vap->iv_flags_ext &
IEEE80211_FEXT_SWBMISS) == 0) {
+ sc->sc_beacons = 1;
+ }
}
break;
case IEEE80211_M_MONITOR:
diff --git a/sys/dev/ath/if_ath_beacon.c b/sys/dev/ath/if_ath_beacon.c
index ac1244c5f8e7..6da36a176319 100644
--- a/sys/dev/ath/if_ath_beacon.c
+++ b/sys/dev/ath/if_ath_beacon.c
@@ -448,9 +448,11 @@ ath_beacon_proc(void *arg, int pending)
* many consecutive beacons reset the device.
*/
if (ath_hal_numtxpending(ah, sc->sc_bhalq) != 0) {
+
sc->sc_bmisscount++;
sc->sc_stats.ast_be_missed++;
ath_beacon_miss(sc);
+
DPRINTF(sc, ATH_DEBUG_BEACON,
"%s: missed %u consecutive beacons\n",
__func__, sc->sc_bmisscount);
@@ -935,15 +937,33 @@ ath_beacon_config(struct ath_softc *sc, struct
ieee80211vap *vap)
u_int32_t nexttbtt_u8, intval_u8;
u_int64_t tsf, tsf_beacon;
- if (vap == NULL)
- vap = TAILQ_FIRST(&ic->ic_vaps); /* XXX */
/*
- * Just ensure that we aren't being called when the last
- * VAP is destroyed.
+ * Find the first VAP that we /can/ use a beacon configuration for.
+ * If it's a STA VAP then if it has SWBMISS set we should ignore it.
+ *
+ * Yes, ideally we'd not have a STA without SWBMISS followed by an
+ * AP STA, and yes this isn't ready for P2P/TSF2 logic on AR9300 and
+ * later chips.
*/
if (vap == NULL) {
- device_printf(sc->sc_dev, "%s: called with no VAPs\n",
- __func__);
+ IEEE80211_LOCK(ic);
+ TAILQ_FOREACH(vap, &ic->ic_vaps, iv_next) {
+ /* A STA VAP w/ SWBMISS set can't be used for beaconing
*/
+ if ((vap->iv_opmode == IEEE80211_M_STA) &&
+ ((vap->iv_flags_ext & IEEE80211_FEXT_SWBMISS) != 0))
+ continue;
+ break;
+ }
+ IEEE80211_UNLOCK(ic);
+ }
+
+ if (vap == NULL) {
+ device_printf(sc->sc_dev, "called with no valid vaps?\n");
+ return;
+ }
+
+ if ((vap->iv_flags_ext & IEEE80211_FEXT_SWBMISS) != 0) {
+ device_printf(sc->sc_dev, "called on VAP with SWBMISS set?\n");
return;
}
@@ -1004,8 +1024,7 @@ ath_beacon_config(struct ath_softc *sc, struct
ieee80211vap *vap)
else
nexttbtt = roundup(nexttbtt, intval);
- DPRINTF(sc, ATH_DEBUG_BEACON, "%s: nexttbtt %u intval %u (%u)\n",
- __func__, nexttbtt, intval, ni->ni_intval);
+
if (ic->ic_opmode == IEEE80211_M_STA && !sc->sc_swbmiss) {
HAL_BEACON_STATE bs;
int dtimperiod, dtimcount;
@@ -1196,8 +1215,8 @@ ath_beacon_config(struct ath_softc *sc, struct
ieee80211vap *vap)
* nexttbtt and intval is TU/8.
*/
if (sc->sc_isedma) {
- nexttbtt_u8 = (nexttbtt << 3);
- intval_u8 = (intval << 3);
+ nexttbtt_u8 = (nexttbtt << 3) & HAL_BEACON_PERIOD_TU8;
+ intval_u8 = (intval << 3) & HAL_BEACON_PERIOD_TU8;
if (intval & HAL_BEACON_ENA)
intval_u8 |= HAL_BEACON_ENA;
if (intval & HAL_BEACON_RESET_TSF)
@@ -1216,6 +1235,15 @@ ath_beacon_config(struct ath_softc *sc, struct
ieee80211vap *vap)
}
ieee80211_free_node(ni);
+ tsf = ath_hal_gettsf64(ah);
+ DPRINTF(sc, ATH_DEBUG_BEACON,
+ "%s: nexttbtt %u intval %u (%u), tsf64=%llu tsfbeacon=%llu
delta=%lld\n",
+ __func__, nexttbtt, intval, ni->ni_intval,
+ (unsigned long long) tsf,
+ (unsigned long long) tsf_beacon,
+ (long long) tsf -
+ (long long) tsf_beacon);
+
ATH_LOCK(sc);
ath_power_restore_power_state(sc);
ATH_UNLOCK(sc);
diff --git a/sys/dev/ath/if_ath_rx.c b/sys/dev/ath/if_ath_rx.c
index 58da21f09638..588194a942db 100644
--- a/sys/dev/ath/if_ath_rx.c
+++ b/sys/dev/ath/if_ath_rx.c
@@ -463,6 +463,7 @@ ath_recv_mgmt(struct ieee80211_node *ni, struct mbuf *m,
sc->sc_syncbeacon &&
(!sc->sc_swbmiss) &&
ni == vap->iv_bss &&
+ ((vap->iv_flags_ext & IEEE80211_FEXT_SWBMISS) == 0)
&&
(vap->iv_state == IEEE80211_S_RUN || vap->iv_state
== IEEE80211_S_SLEEP)) {
DPRINTF(sc, ATH_DEBUG_BEACON,
"%s: syncbeacon=1; syncing\n",
_______________________________________________
dev-commits-src-main@freebsd.org mailing list
https://lists.freebsd.org/mailman/listinfo/dev-commits-src-main
To unsubscribe, send any mail to "dev-commits-src-main-unsubscr...@freebsd.org"
