Hi,
I'm trying to install B2G on my GS2(currently running ICS). I'm working with
LinuxMint 16 - 64 bits.
Building went smooth, but when it comes to flashing, something is going wrong.
I'm not sure what it is.
Here is the output of the ./flash.sh command:
===================
$ ./flash.sh
Heimdall v1.4.0
Copyright (c) 2010-2013, Benjamin Dobell, Glass Echidna
http://www.glassechidna.com.au/
This software is provided free of charge. Copying and redistribution is
encouraged.
If you appreciate this software and you would like to support future
development please consider donating:
http://www.glassechidna.com.au/donate/
Initialising connection...
Detecting device...
Claiming interface...
Attempt failed. Detaching driver...
Claiming interface again...
Setting up interface...
Initialising protocol...
Protocol initialisation successful.
Beginning session...
Some devices may take up to 2 minutes to respond.
Please be patient!
Session begun.
Downloading device's PIT file...
PIT file download successful.
ERROR: Partition "factoryfs" does not exist in the specified PIT.
Ending session...
Rebooting device...
Releasing device interface...
Re-attaching kernel driver...
Heimdall flashing failed.
Make sure you have a line like
SUBSYSTEM=="usb", ATTRS{idVendor}=="04e8", MODE="0666"
in /etc/udev/rules.d/android.rules
=====================
According to the documentation, the error message "Heimdall flashing failed" is
normal. I'm not sure about the "Partition factoryfs does not exist..." one.
The documentation also says:
- All versions of heimdall are unable to flash a system.img larger than 100MB.
My system.img file is over 122MB. Could this be the problem? If so, how can I
flash in two stages, as suggested by the documentation?
What actually happens: I launch flash.sh, the phone reboots in download mode,
and when the error comes up, the phone reboots again under Android.
Thank you
_______________________________________________
dev-b2g mailing list
[email protected]
https://lists.mozilla.org/listinfo/dev-b2g
