Later this evening I found some more problems with my xfree86 install/config:
1. Hardware cursor is not working displaying some garbage instead of cursor image. SW cursor work fine, but I'm afraid hw cursor doesn't work because of memory problems discussed later. 2. If I try to use more than 8192 kb of memory X server crashes successfully after a few minutes of operation. 3. Even when using 8192 or 4096 kb of memory 'x11perf -all' crashes X server within a minute. Seems like all the crashes are caused by the same problem. An error leading to server crash looks the same in all cases. An example XFree86.0.log (gzipped) is attached. XF86Config-4 is attached as well. P.S. I've heard some rumors synaptic touchpad should've been supported since 4.3.0-0pre1v3. As far as I understand it didn't happen. Will it happen in the upcoming releases or the idea has been dropped completely? -- Alexander Barinov Project Manager Banking Technologies Center, Diasoft [EMAIL PROTECTED] http://www.diasoft.ru
XF86Config-4.
Description: Binary data
XFree86.0.log.gz
Description: GNU Zip compressed data
