[added the list back to the cc's of this because it's now a general
question about Xfree86, rather than a specific question about your
message. I hope you (Juliusz) don't mind - none of the content of your
reply seemed particularly private]
Juliusz Chroboczek wrote:
>
> Stuart Ballard wrote:
>
> > How do you do this? With 4.0.[23] and the savage driver, the 1600x1200
> > modeline that I used to use with great success on 3.3.x now fails with
> > "hsync out of range".
>
> That's different. It simply means that your modeline requests an
> hsync value (not a dot clock!) that your Monitor entry claims not to
> support.
Oops - seems I misremembered the error message. This is what it actually
says:
(WW) SAVAGE(0): Mode "1600x1200" deleted (horizontal timing out of
range)
Is that the same problem, or a different one?
> No, most probably you're using a different Monitor entry than you used
> to in 3.*.
This is the XF86Config-4 version of my Monitor section. I just checked
and the old XF86Config from v3 was identical except for a lot of
comments and different identifier strings.
Section "Monitor"
Identifier "Monitor0"
VendorName "Monitor Vendor"
ModelName "Monitor Model"
HorizSync 30-117
VertRefresh 50-160
Option "DPMS"
Modeline "1600x1200" 162 1600 1664 1856 2160 1200 1201 1204
1250 +HSync +VSync
EndSection
(minus the obvious wordwrapping of the modeline done by my mail client)
(Actually, my *current* Xf86-4 has vertrefresh 50-70 for other reasons,
but this doesn't change the error message for the 1600x1200 modeline)
Thanks again for your help!
Stuart.
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
