Hi there, I'm using your potato debs of Branden's Xfree 4.0 packages (version 4.0.1-8), with an AGP Matrox G400, a 2.4.0-test12 kernel compiled with DRI support. Not finding any directions to the contrary, I just installed the packages using apt and then ran xf86cfg. It refused to start up. The log file of the session is attached. If there's something I've obviously missed, I apologise, but I have looked. Is this a bug? Any help would be much appreciated. -- ------------------------------------------------------------ Robert Merkel [EMAIL PROTECTED] "We are excited and optimistic about its usage going forward and, yes, we can teach penguins the military close-order drill", Mark Norton, US Department of Defense. ------------------------------------------------------------
This is a pre-release version of XFree86, and is not supported in any way. Bugs may be reported to [EMAIL PROTECTED] and patches submitted to [EMAIL PROTECTED] Before reporting bugs in pre-release versions, please check the latest version in the XFree86 CVS repository (http://www.XFree86.Org/cvs) XFree86 Version 4.0.1f / X Window System (protocol Version 11, revision 0, vendor release 6400) Release Date: 16 November 2000 If the server is older than 6-12 months, or if your card is newer than the above date, look for a newer version before reporting problems. (See http://www.XFree86.Org/FAQ) Operating System: Linux 2.2.17 i686 [ELF] Module Loader present (==) Log file: "/var/log/XFree86.8.log", Time: Thu Dec 28 01:37:13 2000 (++) Using config file: "/root/XF86Config.new" Parse error on line 43 of section Modes in file /root/XF86Config.new This section must have an Identifier line. (EE) Problem parsing the config file (EE) Error from xf86HandleConfigFile() Fatal server error: no screens found When reporting a problem related to a server crash, please send the full server output, not just the last messages. This can be found in the log file "/var/log/XFree86.8.log". Please report problems to [EMAIL PROTECTED]
