Hello
Joseph (<[EMAIL PROTECTED]>) wrote:
> My network card wasn't recognized after initial bootstrap (base
> installation from floppies).
>
> How to configure network card at this point?
Find out which driver you need and load it. The discover and etherconf
packages can help you to find the right driver and set up the card. You
can also use modconf to load the driver (if it is not already built
into the kernel) and edit /etc/network/interfaces manually.
> I know the network card (eth0) works as it was recognized when I tried
> to boot and install unstable system from floppies.
It depends on the kernel you use, and of course on the card.
best regards
Andreas Janssen
--
Andreas Janssen <[EMAIL PROTECTED]>
PGP-Key-ID: 0xDC801674
Registered Linux User #267976
http://www.andreas-janssen.de/debian-tipps.html
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
