On Fri, 27 Feb 2004, Martin Wood wrote: > Im trying to find some definitive information on configuring serial ATA > drives. > > Im using a 2.4.25 kernel with woody. > The mobo is an Intel 865PERC with an IHC5 controller and the drives are > a pair of Maxtor 7Y250M0.
Get the libata patches from ftp.kernel.org (people/jgarzik). Configure serial ATA (it will be in the *SCSI* sub menu). Configure your ICH5 for _native_ mode (all SATA and PATA drivers available). Your SATA drives will show up as SCSI disks. > The system recognizes the drives but the logs seem to indicate its > treating them as UDMA-33 Ignore that. ICH5 knows better than to talk to a SATA device as if it were a PATA one, no matter what you tell it to. That won't make the disks any faster, obviously. I get a bit more speed than your disks: 50 to 60MB/s depending on my luck (and system load, which I can't stop right now to give you a proper measure). But do use libata, it might improve SATA performance a bit. > hde: attached ide-disk driver. > hde: host protected area => 1 > hde: 490234752 sectors (251000 MB) w/7936KiB Cache, CHS=30515/255/63, > UDMA(33) > hdg: attached ide-disk driver. > hdg: host protected area => 1 > hdg: 490234752 sectors (251000 MB) w/7936KiB Cache, CHS=30515/255/63, > UDMA(33) Here it goes: ata1: SATA max UDMA/133 cmd 0xEC00 ctl 0xE802 bmdma 0xDC00 irq 18 ata2: SATA max UDMA/133 cmd 0xE400 ctl 0xE002 bmdma 0xDC08 irq 18 ata1: dev 0 cfg 49:2f00 82:346b 83:7d01 84:4003 85:3469 86:3c01 87:4003 88:207f ata1: dev 0 ATA, max UDMA/133, 234441648 sectors (lba48) ata1: dev 0 configured for UDMA/133 ata2: dev 0 cfg 49:2f00 82:346b 83:7d01 84:4003 85:3469 86:3c01 87:4003 88:207f ata2: dev 0 ATA, max UDMA/133, 234441648 sectors (lba48) ata2: dev 0 configured for UDMA/133 scsi1 : ata_piix scsi2 : ata_piix Vendor: ATA Model: ST3120026AS Rev: 1.00 Type: Direct-Access ANSI SCSI revision: 05 Vendor: ATA Model: ST3120026AS Rev: 1.00 Type: Direct-Access ANSI SCSI revision: 05 Attached scsi disk sda at scsi1, channel 0, id 0, lun 0 Attached scsi disk sdb at scsi2, channel 0, id 0, lun 0 libata SATA has no SMART support right now, btw. -- "One disk to rule them all, One disk to find them. One disk to bring them all and in the darkness grind them. In the Land of Redmond where the shadows lie." -- The Silicon Valley Tarot Henrique Holschuh -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
