Hello, On Thu, Aug 01, 2024 at 08:54:22AM -0400, gene heskett wrote: > Au contraire Andy.
What a surprise. Here we go again. > The best, most expandable 3d printer driver, klipper, > uses nginx to build its control interface It doesn't matter what niche activities you (or I) engage in on niche hardware that happen to use nginx for reasons you don't know of but assume are "probably" vital. OP has a working apache2 that they are familiar with. If they told me they had a working nginx they are familiar with I'd have told them to stick with that. I am answering based on OP's stated situation. You are answering based on your personal circumstances and still making a big leap of reasoning. > apache2 was probably tested and found wanting. Fact that it's working for OP's use case trumps your vague "probably". If OP had come here with a problem we'd solve it, and that could involve switching to something else. But they didn't. > Most of this stuff is run on stm32 for the hardware interface, > administered by klipper running on one of the better pi clones. > rpi3b's generally are minimum but I'm using several 64 bit > bpi-m5's for that. It doesn't seem that OP is doing anything like that and if they were it would be down to them to state they have an issue with constrained resources. They did not, so your advice is bizarre at best. Andy -- https://bitfolk.com/ -- No-nonsense VPS hosting
