Hi hw,
Having followed through the steps I outlined:
> I'm about to try this on a VM with two disks. I'm going to initially partition
> as if I were using LVM and all in one partition on one disk, then on the other
> That should give me identically sized partitions.
> At that point, I'll change the type on the LVM partitions to RAID, and use
> use the RAID partitioner to make a RAID1 device.
> At that point, I'll change the type on the LVM partitions to RAID, and use
> use the RAID partitioner to make a RAID1 device.
> After that, I'll use one of the ESP partitons and tell the partitioner
> to install all in one partition on the RAID device.
> I'll then change the type of the partition installed to btrfs.
> That should give me EFI - RAID - swap on each of two disks.
> The RAID should be RAID1 and will be mounted as /
This all worked.
I then rebooted into rescue mode, typed in the root password and typed
update-grub /dev/sdb
which appeared to work fine.
Hope this helps, with every good wish as ever,
Andy Cater
