On Wed, Dec 24, 2003 at 01:56:40PM -0000, Martin J Hooper <[EMAIL PROTECTED]> wrote: > Right finally got the module inserted and running! Kewl!
> Used the ati supplied configurator - fed it my monitor horiz and vert > rates from the manual. When I do startx the monitor goes black with > the power light turning yellow. I did not use anything from ATI, but well, I have a different Radeon card. I just think the monitor can't handle the resolution, or [h|v]sync values, recheck that you have them correctly for the right modell of the monitor. > Config is here: > http://www.martinjh.myby.co.uk/XF86Config-4 Please check that your monitor really can use 1280x1024 resolution. Also, you may change the Display subsection to use more modes: Modes "1024x768" "1280x1024" "800x600" And even if you screen goes black, try ctrl+alt+'+' on the keypad and ctrl+alt+'-' to dynamically switch modes. Try the "ati" driver as well. Oh, are you English? Sorry for my poor writing then. :) > Any hints/tips on what I can do to get it actually working? Would it > be better to run dpkg-reconfigure on the xerver to get the required > setup or what? Yup. But even better is 'XFree86 -configure' (maybe with two dashes), and test that configuration. Cheers, GCS -- BorsodChem Joint-Stock Company Linux Support Center Software engineer Developer +36-48-511211/12-99 +36-20-4441745 -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
