Le 28/02/2018 à 21:13, David Wright a écrit :
#
# /etc/interfaces.d/directcable for west 2018-02-25
auto eth0
iface eth0 inet static
address 192.168.2.15/24
Fine. You could also add "allow-hotplug eth0" in case eth0 would be
discovered late.
OK. Tried that here. The ip a is before and after connecting the cable.
(...)
allow-hotplug eth0
iface eth0 inet static
address 192.168.2.15/24
Note : I wrote "also", not "instead".
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group
default qlen 1000
link/ether 00:1c:23:3b:9f:34 brd ff:ff:ff:ff:ff:ff
inet6 fe80::21c:23ff:fe3b:9f34/64 scope link
valid_lft forever preferred_lft forever
Something went wrong. eth0 is up but the IPv4 address defined in
/etc/interfaces.d/directcable is not configured.
Could you post the output of
ifdown -v eth0
ifup -v eth0
