On 08/30/15 21:34, Rick Thomas wrote:
I’ll plug in a disk and test it next chance I get, if you think it will help.
Plugging the disk in after reboot shows nothing happening with the USB3
card.
Plugging it into the USB2 card gets the expected
[ 372.956020] usb 8-3: new high-speed USB device number 2 using ehci-pci
[ 373.097430] usb 8-3: New USB device found, idVendor=05dc,
idProduct=a838
[ 373.097434] usb 8-3: New USB device strings: Mfr=1, Product=2,
SerialNumber=3
[ 373.097437] usb 8-3: Product: USB Flash Drive
[ 373.097439] usb 8-3: Manufacturer: Lexar
[ 373.097442] usb 8-3: SerialNumber: AALBOCEKDL6LQK8A
[ 373.129075] usb-storage 8-3:1.0: USB Mass Storage device detected
[ 373.129229] scsi host5: usb-storage 8-3:1.0
[ 373.129364] usbcore: registered new interface driver usb-storage
[ 373.143513] usbcore: registered new interface driver uas
[ 374.434275] scsi 5:0:0:0: Direct-Access Lexar USB Flash
Drive 1100 PQ: 0 ANSI: 6
[ 374.434685] sd 5:0:0:0: Attached scsi generic sg4 type 0
[ 374.436135] sd 5:0:0:0: [sdc] 62517248 512-byte logical blocks:
(32.0 GB/29.8 GiB)
[ 374.436998] sd 5:0:0:0: [sdc] Write Protect is off
[ 374.437002] sd 5:0:0:0: [sdc] Mode Sense: 43 00 00 00
[ 374.437878] sd 5:0:0:0: [sdc] Write cache: enabled, read cache:
enabled, doesn't support DPO or FUA
[ 374.453902] sdc: sdc1 sdc2
[ 374.458001] sd 5:0:0:0: [sdc] Attached SCSI removable disk
