Bob Proulx <b...@proulx.com> writes: > csanyi...@gmail.com wrote: >> Bob Proulx writes: >> > csanyi...@gmail.com wrote: >> >> What could be the problem? >> > >> > I don't know but here is my working configuration. I am not running >> > in bridge mode. I am running in router mode. >> >> I tried this setup but after reboot my headless server I can't ssh into >> it again. > > I am hoping that you took the example as an example and modified it > appropriately for your environment? > >> I must to rescue it to get it back. > > Sounds good. Rescue it and then debug and fix it. You said it was a > Power PC. I have no experience with them and have no information to > advise you on how to rescue it. If it were an x86 system then I would > recommend using the debian-installer in rescue mode. I have no idea > about Power PC systems.
I did it, I get back with a rescue USB image, that is actually a Bubba 2 installation image. >> Should I run some route commands to get it working? > > That suggestion is a non-sequitur until you know why your system is > not talking. Diagnose what is wrong first. After you know and > understand what is wrong then the action to take to fix it will also > be known. I understand. I accept your advice and I shall diagnose what is wrong first. >> Anyway I plan my home network in Dia and export it to an image: >> https://www.dropbox.com/s/shbcf2ukcj429v1/HomeNetwork_02.png?dl=0 > > Good picture. With the exception of drawing three separate firewalls > where I think one on Bubba2 is actually what exists. Indeed, the three separate firewalls is actually one firewall for three NIC's ( network interfaces ): eth0, eth1 and wlan0. >> I'm persistently looking for a solution for this case. >> >> Any advices will be appreciated! > > How do you normally access your headless PowerPC server? I am sure > using ssh but when not using ssh? For me if it did not have a > graphics display and keyboard I would configure a serial console so > that at least when networking is offline I could use the serial > console for access. I shall make a serial console access to my Bubba 2 soon. -- Regards from Pal -- To UNSUBSCRIBE, email to debian-user-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org Archive: https://lists.debian.org/87383ckssq....@gmail.com
