Veljko wrote: > I'm using four 3TB drives, so I had to use GPT. Although I'm pretty > sure I know what I need to do, I want to make sure so I don't loose > data. Three drives are dying so I'm gonna replace them one by one.
Sounds like a good plan to me. It is what I would do. It is what I have done before when upgrading sizes to larger sizes. > This is what I plan to do: > Replacing sda > ... > Did I overlook something? Will this going to work? Very well thought out plan! Looks okay to me. I like it. Some boot issues to discuss however. Is this a BIOS boot ordering boot system booting from sda? In which case replacing sda won't have an MBR to boot from. You can probably use your BIOS boot to select a different disk to boot from. And then after having booted install grub on the other disk. (Sometimes the BIOS boot order will be quite different from the Linux kernel drive ordering.) I am unfamiliar with the sgdisk backup and load-backup operation. I am not sure that will restore the grub boot sector. This isn't too scary because you can always boot one of the other drives. Or boot a debian-install rescue media. But after setting up the replacement disk it will probably be necessary to install grub upon it in order for it to be bootable as the first BIOS boot media. And very often I have found that a second disk that I thought should have had grub installed upon it did not and when removing sda I find that the system won't grub boot from sdb. Therefore I normally restore sda, boot, install grub on sdb, then try again. But if you know ahead of time you can re-install grub on sdb and avoid the possible hiccup there. But if you are concerned about writes to sdb then I would simply plan to boot from the debian-installer image in rescue mode, assemble the raid, sync, then replace sdb, and repeat. You can always install grub to the boot sectors after replacing the suspect disks. Hopefully this makes sense. > I was also thinking about inserting one drive and copying data from > RIAD to it so I have backup if something goes wrong. Would that be > right thing to do, or that would just load drives unnecessarily and > accelerate their failure? Are you asking about the one drive inserted being large enough to do a full system backup? If so then I think it is hard to argue against a full backup. I think I would do the full backup even with the extra disk activity. It is read, not write, and so not as bad as normal read-write disk activity. In which case you might consider that instead of replacing all disks one by one that you could simply do a full backup, then create the new system with lvm and raid as desired, and then restore the backup onto the newly constructed partitions. After you have the full backup then your original drives would be shut off and available as a backup image too in that case. So that also seems a very safe operation. Or since you have four new drives go ahead and construct a new base configuration with the four new drives with lvm+raid as desired. And then clone directly from the old system disks to the new system disks. Then boot the new system disks. This has much more offline time than the replace one disk at a time that you outlined above. I normally do the sync one disk at a time since the system is online and running services normally during the sync. But there are many ways to accomplish the task. Bob
signature.asc
Description: Digital signature
