Hello:
I finally upgraded to Wheezy and GDM3 in August. Since then, my
Postscript printer which functioned correctly under GDM2 outputs
ONLY blank pages when print requests are submitted to CUPS.
The printer does function correctly if I run:
cat PS_FILE.ps > /dev/lp0
But using "lp PS_FILE.ps" or "lp FILE.txt" outputs only a blank
page. Similar results occur if I print from ghostview for
example.
Any ideas on where to look, or what config file might need
tweaking?
Thanks,
Dean
--
Dean Provins, P. Geoph.
[email protected]
http://www.telusplanet.net/~provinsd
public key 0x9643AE65
9B79 75FB 5C2B 22D0 6C8C 5A87 D579 9BE5 9643 AE65
--
To UNSUBSCRIBE, email to [email protected]
with a subject of "unsubscribe". Trouble? Contact [email protected]
Archive: http://lists.debian.org/[email protected]
