Never mind ... usb-uhci was in /etc/modules Dooh!!! Lou Losee * Lou Losee <[EMAIL PROTECTED]> [2003-10-08 17:12]: > Hi, Currently on boot, my system is loading the usb-uhci module. I am > trying to change that to get it to load the uhci module instead. I am > running a custom 2.4.22 kernel if that matters. I want uhci instead of > usb-uhci based on the following output I get from a lspci -v | grep HCI > command: > > 00:07.2 USB Controller: Intel Corp. 82371AB/EB/MB PIIX4 USB (rev 01) (prog-if 00 > [UHCI]) > 00:0b.0 USB Controller: VIA Technologies, Inc. USB (rev 50) (prog-if 00 [UHCI]) > 00:0b.1 USB Controller: VIA Technologies, Inc. USB (rev 50) (prog-if 00 [UHCI]) > 00:0b.2 USB Controller: VIA Technologies, Inc. USB 2.0 (rev 51) (prog-if 20 [EHCI]) > > Based on some input from the hpoj list, I added the following line to > the aliases file in /etc/modutils and ran update-modules: > > alias usb-controller uhci > > That did not work, usb-uhci still loaded after a power down and reboot > (I was also told that a simple modprobe -r usb-uhci followed by a > modprobe uhci would not work and to power down the system after > changing) - shades of that *other* operating system. > > So, then based on information in the FAQ at linux-usb.org, I removed the > previous line I added and added the following lines instead: > > alias usb uhci > post-install uhci modprobe printer > > Again after running update-modules powering down and rebooting usb-uhci > still gets loaded!!!! > > Help - any ideas on how to get this to work???? > > Lou Losee > > > -- > To UNSUBSCRIBE, email to [EMAIL PROTECTED] > with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED] >
-- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
