On 8/9/2011 2:40 AM, [email protected] wrote: > remote refid st t when poll reach delay offset jitter > ============================================================================== > ntp1.inrim.it .CTD. 1 u 46 64 377 23.641 329686. 2517.77 > ntp2.inrim.it .CTD. 1 u 29 64 377 25.236 329834. 2524.50 > > > 2.6.32-5-amd64 #1 SMP Tue Jun 14 09:42:28 UTC 2011 x86_64 GNU/Linux
Is this a virtual machine guest or bare metal host? Usually offsets this large are only seen on VM guests that aren't setup properly, and/or riding atop improperly configured hypervisors. If this is a guest, configure the underlying host to sync with an NTP pool, enable the ntpd listener on the host ntpd, and configure the guest ntpd to query the underlying host. Never sync a guest OS ntpd to anything but the underlying host. You'll also need to stop ntpd in the guest, run ntpdate once against your host IP, then start the guest ntpd again. If this is a bare metal host then you probably have a hardware problem. In that case your system board will probably need to be replaced. -- Stan -- To UNSUBSCRIBE, email to [email protected] with a subject of "unsubscribe". Trouble? Contact [email protected] Archive: http://lists.debian.org/[email protected]
