> Have you installed 'firmware-linux'? There is 3 packages. -- > Jimmy Johnson
Thanks for you're advice, I did that now and it somewhat helped. That is the port works fine -- when I connect something it gets detected and mounted. But the annoying message is still there during boot. When I run "dmesg" I get a couple of tens of the following two lines: [ 76.966101] usb 1-1.5: new full speed USB device using ehci_hcd and address X [ 76.982454] hub 1-1:1.0: unable to enumerate USB device on port 5 These messages continue through all the session, only the numbers in the [] braces and the "X" change. You can imagine I'd like them to go away. Any ideas? Regards, KB -- To UNSUBSCRIBE, email to [email protected] with a subject of "unsubscribe". Trouble? Contact [email protected] Archive: http://lists.debian.org/[email protected]
