Daniel Bareiro put forth on 6/12/2010 12:41 PM: > Hi all! > > I'm doing tests with a brand new HP Storageworks 1/8 G2 I plan to use > with Bacula on Debian GNU/Linux Lenny. > > The tape autoloader is connected to a PC through an HP Smart Array P212 > card. It is HP's entry level PCI Express Serial Attached SCSI RAID > controller. > > In these initial tests I intend to make the autoloader and the drive to > recognize commands sent using mtx and mt, respectively. > > However, in the operating system I'm only seeing the tape drive, but not > the autochanger: > > backup:~# cat /proc/scsi/scsi > Attached devices: > Host: scsi3 Channel: 00 Id: 00 Lun: 00 > Vendor: ATA Model: ST3160211AS Rev: 3.AA > Type: Direct-Access ANSI SCSI revision: 05
This is a Seagate SATA disk drive: http://www.seagate.com/ww/v/index.jsp?vgnextoid=2ab099f4fa74c010VgnVCM100000dd04090aRCRD&locale=en-US You're apparently not seeing any component of the tape library unless there are other entries in /proc/scsi/scsi which you did not share. -- Stan -- To UNSUBSCRIBE, email to debian-user-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org Archive: http://lists.debian.org/4c1439ce.8030...@hardwarefreak.com
