This problem is not isolated to ehci_hcd. I am able to print with just ohci_hcd or uhci_hcd, but in either case the module has to be loaded AFTER the printer is on.
There must be a simple fix to this. Can anyone help? --- On Thu, 2/18/10, Jen Craigson <jenniscompu...@ymail.com> wrote: > From: Jen Craigson <jenniscompu...@ymail.com> > Subject: ehci_hcd has to be manually reloaded for USB 2.0 printer > To: debian-user@lists.debian.org > Date: Thursday, February 18, 2010, 5:44 PM > Hi everybody, > > Well I finally made the upgrade to Lenny, and my USB > printers only work when the ehci_hcd module is loaded after > the printer is on. If I set it to load a boot and the > printer's off, I have to "rmmod ehci_hcd; modprobe ehci_hcd" > once the printer is on again before it will work. > > Before the upgrade to Lenny, everything was going fine. I > have an HP > LaserJet 4MPlus connected with a parallel-to-USB cable. > CUPS is fine. But if ehci_hcd isn't loaded (or if it's > loaded before the printer is one), when I send a print job > it's always just "processing" forever, and nothing is > actually sent to the printer until that module gets > reloaded. > > Is there a way to make it automagically reload when a USB > printer goes on? > > Or is there another fix to this problem? > > I appreciate the help. This has me stumped! > > THANK YOU SO MUCH! > > Jen > > > > > -- To UNSUBSCRIBE, email to debian-user-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org Archive: http://lists.debian.org/372638.67057...@web113901.mail.gq1.yahoo.com
