Hi, On Sun, Nov 22, 2009 at 1:19 AM, <whollyg...@letterboxes.org> wrote: > Everything I've read so far on xen networking > leads me to believe that I should have a bridge > named xenbr0 and a virtual interface vif0.0 > for dom0. The bridge appears to be named eth0 > here: > > ------------------- > # ifconfig > eth0 Link encap:Ethernet HWaddr 00:11:09:62:29:04 > inet addr:192.168.153.200 Bcast:192.168.153.255 > Mask:255.255.255.0 > inet6 addr: fe80::211:9ff:fe62:2904/64 Scope:Link > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:4833 errors:0 dropped:0 overruns:0 frame:0 > TX packets:4687 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:0 > RX bytes:289823 (283.0 KiB) TX bytes:307062 (299.8 KiB) > > lo Link encap:Local Loopback > inet addr:127.0.0.1 Mask:255.0.0.0 > inet6 addr: ::1/128 Scope:Host > UP LOOPBACK RUNNING MTU:16436 Metric:1 > RX packets:92 errors:0 dropped:0 overruns:0 frame:0 > TX packets:92 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:0 > RX bytes:10834 (10.5 KiB) TX bytes:10834 (10.5 KiB) > > peth0 Link encap:Ethernet HWaddr 00:11:09:62:29:04 > inet6 addr: fe80::211:9ff:fe62:2904/64 Scope:Link > UP BROADCAST RUNNING PROMISC MULTICAST MTU:1500 Metric:1 > RX packets:4833 errors:0 dropped:0 overruns:0 frame:0 > TX packets:4698 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:357521 (349.1 KiB) TX bytes:307928 (300.7 KiB) > Interrupt:20 Base address:0xa000 > > vif1.0 Link encap:Ethernet HWaddr fe:ff:ff:ff:ff:ff > inet6 addr: fe80::fcff:ffff:feff:ffff/64 Scope:Link > UP BROADCAST RUNNING PROMISC MULTICAST MTU:1500 Metric:1 > RX packets:0 errors:0 dropped:0 overruns:0 frame:0 > TX packets:56 errors:0 dropped:124 overruns:0 carrier:0 > collisions:0 txqueuelen:32 > RX bytes:0 (0.0 B) TX bytes:9408 (9.1 KiB) > > > > # brctl show > bridge name bridge id STP enabled interfaces > eth0 8000.001109622904 no peth0 > vif1.0 > ---------------------------- > > So how does dom0 talk to the network?
dom0# ip route You are building a bridge with peth0 as phisical nic which was eth0 before xen was installed in your server. Regards, -- To UNSUBSCRIBE, email to debian-user-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org
