Murray J. Brown wrote: > I've tried to install both Woody 3.0r1 & Sarge (2003-07-27) from an
It is not clear to me which kernel you are installing by this description. For the woody install which kernel did you select? If you just hit 'enter' then you got the 2.2 kernel. If you said bf24 then you got the 2.4 kernel. I have seen the 2.2 kernel hang when the 2.4 kernel would install properly. > ATAPI CDROM (40x/AKU) onto a PC with a new Intel P4C800 Deluxe > motherboard, a 200GB WD Serial ATA drive and a 80GB (WD800JB-00ETA0) > drive, but the install process just hangs while probing (or simply > loading the ide-mod-probe kernel module) for IDE controllers. At first, > I thought it might be the S-ATA support, so I disconnected that drive > but the probing still consistently fails at the 33.3% mark while trying > to detect the remaining IDE drives, even after trying various > permutations of BIOS settings. Disconnecting the drive won't disable the controller. Possibly disabling the controller in the BIOS would get past this problem. > Redhat 9 installs cleanly so I know the hardware works. However, I'd > rather use Debian for consistency across all my systems (now that I've > eradicated Windoze). Obviously most of us on this list would agree with you. :-) > Suggestions anyone? Any help will be appreciated. Another suggested doing installing KNOPPIX on the hard drive. I really like KNOPPIX as a good use of technology. But I have tested installing older versions to a hard drive and then trying to upgrade them to newer versions of software. It can be a can of worms at that time. I can't recommend it unless you are already an expert. As the saying goes if you have to ask then you are not one. Note that this is not something that Klaus Knopper tried to create when he created KNOPPIX. He created the image for himself and released it to others because it is really sweet. But getting an image fully up to date can be tricky. Instead let me suggest something else entire. This is also a little complicated. So don't feel obgligated if this does not work out. But I would use knoppix to boot a system off of the cdrom and then use rsync to copy an existing system which is up to date and has the latest kernel onto your hard drive. I suggest this since it sounds like you have several machines at your disposal. Partition the drive, run mkswap on the swap partition, run mkfs on the filesystem, copy the system onto the drive, customize the /etc/modules, /etc/hostname, /etc/mailname, /etc/fstab, etc., run lilo (or grub) and then boot the system. I find this an easy way to create new systems by cloning other ones. I can furnish a complete list of files to customize if you need one but I think you get the idea. The raw copy of the system onto a new machine takes about six minutes on my machines, usually much faster than installing the data as packages. But then you spend another 15 minutes editing files to change the system over to its new personality. That assumes that your only real problem is that you need a newer kernel than what exists on your installation media. If you need something else than this won't work either. Bob
pgp00000.pgp
Description: PGP signature
