Boyd Stephen Smith Jr. wrote:
On Wednesday 2008 December 17 23:30:04 M.Lewis wrote:
Boyd Stephen Smith Jr. wrote:
On Wednesday 2008 December 17 23:00:41 M.Lewis wrote:
Given a Lenny LVM setup as follows:
rattler:~# lvs
LV VG Attr LSize Origin Snap% Move Log
Copy% Convert
home rattler -wi-ao 65.02G
root rattler -wi-ao 6.68G
swap_1 rattler -wi-ao 2.59G
Is it possible to reorganize the current LVM to separate out say /var &
/tmp into their on LV?
Any free space on the VG? Or, can you make some by shrinking one of the
filesystems and then shrinking it's associated VG?
No, free space is all used in LVs. Yes, I can shrink /home easily by
10-20GB.
Then, I'd:
--- Prep ---
1. Go down to or boot into single-user mode.
2. Unmount /home
3. Size down /home and then rattler/home
4. Optional: make sure the /home filesystem is still fine -- at this point
reverting the lv shrinking is fairly easy.
---
5. Make new lvs for /var and /tmp. (BTW, if you have 1G or more, you might
just put /tmp on tmpfs.)
6. Make the new filesystems for /var and /tmp.
7. If possible, remount / read-only. If writing isbeing done to files in the
old /var or /tmp during or after the rsync, you'll lose some of that data
8. Mount the new /var and /tmp in the right place.
--- Data Migration ---
9. Mount with -o bind / on /mnt.
10. Rsync /mnt/var/. to /var and /mnt/tmp/. to /tmp.
11. rm -rf /mnt/{var,tmp}/{.[!.],}*
12. Umount /mnt.
--- Finishing touches --
13. Add new /var and /tmp to /etc/fstab.
14. Reboot normally or simply walk the system up to your normal multi-user run
level.
Relevant manpages:
1. init
2. umount
3. filesystem-specific e.g. resize_reiserfs; lvreduce
4. fsck; If you need to undo the lvreduce, vgcfgrestore
5. lvcreate
6. mkfs
7. mount (options: remount,ro)
8. mount
9. mount (options: bind)
10. rsync
11. rm
12. umount
13. fstab
14. init
Write back if you need more details.
Thanks Boyd. After reading through it a couple of times, it appears
pretty straight forward.
I had thoughts of reinstalling (with the partitioning/LVM setup right),
but that would mean I'd have to sort out somehow which additional
packages that I have installed since the original install. Seems like
your method is probably faster without all the overhead of figuring out
the additional packages.
I'll mull this over some more.
Thanks,
Mike
--
If at first you don't succeed, you must be a programmer.
01:00:02 up 1 day, 37 min, 1 user, load average: 0.86, 0.91, 0.68
Linux Registered User #241685 http://counter.li.org
--
To UNSUBSCRIBE, email to debian-user-requ...@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org
