After copying one CD, I find cdrecord losing it's permission to write to the blank for a second, new CD. Any thoughts why this is happening? Info is in the debugging output below. I was running Fluxbox after a reboot.
FWIW I have difficulties as well getting the Plextor drive to be recognized under Gnome, with it winding up spitting out "not ready" messages on every terminal screen following attempts to use K3B or any other CD software. I've had to reboot to reset things. Is this a hald issue perhaps? TIA for any help! Kenward ------------------- Below is the debugging output from K3B: System ----------------------- K3b Version: 1.0.5 KDE Version: 3.5.9 QT Version: 3.3.8b Kernel: 2.6.26 Devices ----------------------- LITE-ON DVD D LH-16D1P TL13 (/dev/hdb, ) [CD-ROM, DVD-ROM] [DVD-ROM, CD-ROM] [None] PLEXTOR DVDR PX-708A 1.03 (/dev/hda, ) [CD-R, CD-RW, CD-ROM, DVD-ROM, DVD-R, DVD-RW, DVD+R, DVD+RW] [DVD-ROM, DVD-R Sequential, DVD-RW Restricted Overwrite, DVD-RW Sequential, DVD+RW, DVD+R, CD-ROM, CD-R, CD-RW] [SAO, TAO, RAW, SAO/R96P, SAO/R96R, RAW/R16, RAW/R96P, RAW/R96R, Restricted Overwrite] Used versions ----------------------- cdrecord: 1.1.8 cdrecord ----------------------- /usr/bin/wodim: Operation not permitted. Warning: Cannot raise RLIMIT_MEMLOCK limits.scsidev: '/dev/hda' devname: '/dev/hda' scsibus: -2 target: -2 lun: -2 Linux sg driver version: 3.5.27 Wodim version: 1.1.8 SCSI buffer size: 64512 Beginning DMA speed test. Set CDR_NODMATEST environment variable if device communication breaks or freezes immediately after that. TOC Type: 0 = CD-DA Driveropts: 'burnfree' Device type : Removable CD-ROM Version : 0 Response Format: 1 Vendor_info : 'PLEXTOR ' Identification : 'DVDR PX-708A ' Revision : '1.03' Device seems to be: Generic mmc2 DVD-R/DVD-RW. Current: 0x0009 (CD-R) Profile: 0x001B (DVD+R) Profile: 0x001A (DVD+RW) Profile: 0x0014 (DVD-RW sequential recording) Profile: 0x0013 (DVD-RW restricted overwrite) Profile: 0x0011 (DVD-R sequential recording) Profile: 0x0010 (DVD-ROM) Profile: 0x000A (CD-RW) Profile: 0x0009 (CD-R) (current) Profile: 0x0008 (CD-ROM) Using generic SCSI-3/mmc CD-R/CD-RW driver (mmc_cdr). Driver flags : MMC-3 SWABAUDIO BURNFREE Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P RAW/R96R Drive buf size : 1190112 = 1162 KB Drive DMA Speed: 1341 kB/s 7x CD 0x DVD FIFO size : 12582912 = 12288 KB Encoding speed : 909x (68123 sectors/s) for libedc from Heiko Eißfeldt Track1 Start: '32' (32) pregap1: 182 Track 01: audio 38 MB (03:49.70) no preemp pregapsize: 182 Track 02: audio 10 MB (01:02.86) no preemp pregapsize: 0 ... Track 25: audio 18 MB (01:52.77) no preemp pregapsize: 0 Total size: 548 MB (54:17.80) = 244335 sectors Lout start: 548 MB (54:19/60) = 244335 sectors Current Secsize: 2048 ATIP info from disk: Indicated writing power: 5 Is not unrestricted Is not erasable Disk sub type: Medium Type A, high Beta category (A+) (3) ATIP start of lead in: -11634 (97:26/66) Speed set to 7056 KB/s /usr/bin/wodim: DMA speed too slow (OK for 6x). Cannot write at speed 40x. ATIP start of lead out: 359846 (79:59/71) Disk type: Short strategy type (Phthalocyanine or similar) Manuf. index: 3 Manufacturer: CMC Magnetics Corporation Blocks total: 359846 Blocks current: 359846 Blocks remaining: 115511 Starting to write CD/DVD at speed 40.0 in real RAW/RAW96R mode for single session. Last chance to quit, starting real write in 2 seconds. 1 seconds. 0 seconds. Operation starts. Waiting for reader process to fill input buffer ... input buffer ready. Performing OPC... Errno: 0 (Success), write_g1 scsi sendcmd: no error CDB: 2A 00 FF FF D4 7C 00 00 1A 00 status: 0x2 (CHECK CONDITION) Sense Bytes: F0 00 03 FF FF D5 12 0A 00 00 00 00 0C 07 00 00 Sense Key: 0x3 Medium Error, Segment 0 Sense Code: 0x0C Qual 0x07 (write error - recovery needed) Fru 0x0 Sense flags: Blk -10990 (valid) resid: 63648 cmd finished after 1.861s timeout 40s /usr/bin/wodim: Could not write Lead-in. Writing lead-in at sector -11634 write leadin data: error after 1209312 bytes Writing time: 30.620s /usr/bin/wodim: fifo had 191 puts and 0 gets. /usr/bin/wodim: fifo was 0 times empty and 0 times full, min fill was 100%. cdrecord command: ----------------------- /usr/bin/wodim -v gracetime=2 dev=/dev/hda speed=40 -raw96r driveropts=burnfree -eject -text -useinfo -audio -shorttrack /opt/film/k3bCdCopy0/Track01.wav /opt/film/k3bCdCopy0/Track02.wav /opt/film/k3bCdCopy0/Track03.wav /opt/film/k3bCdCopy0/Track04.wav /opt/film/k3bCdCopy0/Track05.wav /opt/film/k3bCdCopy0/Track06.wav /opt/film/k3bCdCopy0/Track07.wav /opt/film/k3bCdCopy0/Track08.wav /opt/film/k3bCdCopy0/Track09.wav /opt/film/k3bCdCopy0/Track10.wav /opt/film/k3bCdCopy0/Track11.wav /opt/film/k3bCdCopy0/Track12.wav /opt/film/k3bCdCopy0/Track13.wav /opt/film/k3bCdCopy0/Track14.wav /opt/film/k3bCdCopy0/Track15.wav /opt/film/k3bCdCopy0/Track16.wav /opt/film/k3bCdCopy0/Track17.wav /opt/film/k3bCdCopy0/Track18.wav /opt/film/k3bCdCopy0/Track19.wav /opt/film/k3bCdCopy0/Track20.wav /opt/film/k3bCdCopy0/Track21.wav /opt/film/k3bCdCopy0/Track22.wav /opt/film/k3bCdCopy0/Track23.wav /opt/film/k3bCdCopy0/Track24.wav /opt/film/k3bCdCopy0/Track25.wav -- The church says the earth is flat, but I know that it is round, for I have seen the shadow on the moon, and I have more faith in a shadow than in the church. --Ferdinand Magellan -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
