Hi all,
I have a sagem fast 800 (ueagle-atm) module on my gateway. I have
difficulties to synchronize because i'm far (very far) from the dslam.
So, when it loses synchronisation, the modem can take hours before
re-sync. Sometimes, it can't sync and I get error messages like these ones :
Oct 6 11:49:20 localhost kernel: ATM dev 0: usbatm_complete: urb
0xcb2f2cc0 failed (-71)!
Oct 6 11:49:20 localhost kernel: usb 1-1: [UEAGLE-ATM] uea_intr()
failed with -84
Oct 6 11:49:20 localhost kernel: ATM dev 0: usbatm_complete: urb
0xcb2f2ac0 failed (-71)!
Oct 6 11:49:20 localhost kernel: usb 1-1: [UEAGLE-ATM] sending DSP
block 0 failed
Oct 6 11:49:20 localhost kernel: ATM dev 0: usbatm_complete: urb
0xc5a03a60 failed (-71)!
Oct 6 11:49:20 localhost kernel: ATM dev 0: usbatm_complete: urb
0xcc8fd740 failed (-71)!
Oct 6 11:49:20 localhost kernel: usb 1-1: USB disconnect, address 96
Oct 6 11:49:20 localhost kernel: ATM dev 0: usbatm_submit_urb: urb
0xcb199e80 submission failed (-19)!
Oct 6 11:49:20 localhost kernel: ATM dev 0: usbatm_submit_urb: urb
0xcb199e80 submission failed (-19)!
Oct 6 11:49:24 localhost kernel: usb 1-1: [UEAGLE-ATM] usb_control_msg
error -19
Oct 6 11:49:24 localhost kernel: usb 1-1: [ueagle-atm] ADSL device removed
At this moment, I must unplug the modem, wait 5 to 10 seconds and
re-plug it.
I would like to be able to eject with a script the modem. So, i will
scan every minute my syslog and when it found an error, the script will
be launch.
I have tried a script months ago that unload the module (and the usb
module) but it doesn't work, it seems it doesn't find a new hardware (no
new usb event on syslog).
Is there a way to eject the hardware (via udev or anything else) ?
Thanks in advance,
Christophe
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
