Hi,
I have a USB printer, HP laserjet 1600. I'm using lenny, with cups
and the hpijs driver installed. The printer used to work, although it
would sometimes stop due to an error. Restarting the printer usually
got it working again. Recently, probably after an upgrade, it stopped
working altogether. The printer is still detected, and if I print to
it, the job is listed in kjobviewer, and shows up if I connect to the
cups server (localhost:631), but the printer does not do anything, and
the menu panel states "Ready". I can still print to a remote printer,
so I suspect it is a problem with the USB system, not cups itself.
Does anyone have a clue as to what could be wrong, or how I would go
about debugging this?
-Chris
------------------------------------------------------------------------
| Christopher Judd, Ph.D. [EMAIL PROTECTED] |
------------------------------------------------------------------------
IMPORTANT NOTICE: This e-mail and any attachments may contain
confidential or sensitive information which is, or may be, legally
privileged or otherwise protected by law from further disclosure. It
is intended only for the addressee. If you received this in error or
from someone who was not authorized to send it to you, please do not
distribute, copy or use it or any attachments. Please notify the
sender immediately by reply e-mail and delete this from your
system. Thank you for your cooperation.
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
