On Thu, Aug 21, 2008 at 08:19:56AM +0200, Florian Kulzer wrote:
> On Wed, Aug 20, 2008 at 22:49:22 -0400, Kumar Ravichandran wrote:
> > On Thu, Aug 21, 2008 at 12:05:42AM +0200, Florian Kulzer wrote:
>
> [...]
>
> > > How long did you wait after these messages appeared? On my system it
> > > takes about 2-5 seconds more for the following to show up:
> > >
> > > 23:50:53.743: volume_uuid_487F_1EC0 added
> > > 23:50:53.878:
> > > storage_serial_Prolific_Technology_Inc__USB_Mass_Storage_Device added
> > > 23:50:53.880:
> > > storage_serial_Prolific_Technology_Inc__USB_Mass_Storage_Device property
> > > info.interfaces = {'org.freedesktop.Hal.Device.Storage.Removable'} (new)
> > >
> > > You should see similar output eventually, or something might be wrong
> > > with HAL.
> > >
> >
> > You are right, I don't get any further messages. What do you suggest I
> > do about Hal? I have tried reinstalling it already.
>
> How is the overall state of your system, is it fully upgraded? I ask
> because your version of Mutt is too new for Etch, but older than what
> you should have for up-to-date Lenny or Sid. Is it possible that you ran
> into a problem that has long been fixed on current Lenny/Sid, or a bug
> that is only present for a certain mix of more-or-less outdated
> packages?
Well, my initial install was from the Etch DVDs, but I had a mixture
of Etch and lenny for a while. I recently did a dist-upgrade to lenny,
but have a few sid packages from somewhere (I think during a failed
KDE 4.1 install attempt). Anyway, I had Etch/lenny when the automount
stopped working. I hope that answers your question.
--
Regards,
Kumar.
--
Kumar Ravichandran
Graduate Research Assistant
Department of Aerospace Engineering
University of Maryland
College Park, MD.
"An eye for an eye will only make the entire world blind."
- Mohandas Karamchand Gandhi
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
