On Wed, May 14, 2008 at 01:36:25PM -0700, Alan Ianson wrote: > On Wed May 14 2008 01:01:28 pm charliesdad wrote: > > I have etch. After 4 months I still can't get the printer to work. It is > > a HP DeskJet 722C. I have installed pnm2ppa from disk 9. I use gnome and > > had it print a test page. The printer started, printed one funny > > character and hung. I went to /etc and set up the values in the config > > file. It now dies with a rasterto ... error. > > > > I don't want to install source code and anything else other than just > > PRINT! How do I do it? > > The way I install my printer is to enter localhost:631 in my browser and set > it up there. It'll probably be self explanatory on that page. Once you get it > installed you'll need to log out of your session and log back in again.
That of course assumes that the OP is using CUPS as a spooler and print filter. Doug. -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
