Hi everyone, I hope this wasn't coverd in the past, but I couldn't find anything.
I installed an etch on a machine, which has a new SATA Controller. lspci tells me this about the device: 00:09.0 RAID bus controller: Silicon Image, Inc. SiI 3114 [SATALink/SATARaid] Serial ATA Controller (rev 02) My mainboard is an Gygabyte GA-7IXE4. Etch recognizes the controller during hardware detection, but when the module sata_sil gets loaded, I get this output: sata_sil 0000:00:09.0: version 2.0 ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 11 PCI: setting IRQ 11 as level-triggered ACPI: PCI Interrupt 0000:00:09.0[A] -> Link [LNKB] -> GSI 11 (level, low) -> IRQ 11 PCI: Unable to reserve I/O region #1:[EMAIL PROTECTED] for device 0000:00:09.0 sata_sil: probe of 0000:00:09.0 failed with error -16 I don't know if I am doing anything wrong, or if this is a bug. I changed PCI Slots, but this doesn't help either. Any hints? Martin -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
