I have built a new system using:
Etch with kernel 2.6.18-6-k7
Tyan Thunder h1000E Motherboard
2 Dual-Core AMD Opteron Processors
Two hard drives: #1 on the builtin IDE - hda
#2 on an PCI card - hdc
The system always boots from #1 but sometimes, the kernel gets
confused and assigns #2 as hda and #1 as hde. When this happens, the
boot fails because #2 has two empty partitions.
I can enter reboot and sometimes the system will come up with the
disk set correctly and sometimes not.
This problem also happened on Etch with kernel 2.6.18-5-k7.
I would welcome suggestions for what is causing the problem and how
to correct it.
Thanks.
Butch
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
