-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Hi All,
A little while back I was trying to fix a system that was producing
a continuous tone after being unused for a while, then logging in.
Now it's running a wee mite slow....
time top -n 1 > output.txt
real 67m42.116s
user 0m0.008s
sys 0m0.000s
Yep - it took it over an hour to run top once and put the output in a
file. Then it started beeping again.
I had to hard reboot it (the noise was driving me batty) and guess
what - output.txt is nowhere to be found!
I did see the file before I rebooted - cpu was 0%us 0%ni 89%id,
swap was 0k used and the first process listed was using less than 2%
cpu.
After the reboot it seems to run fine - the software RAID rebuilds
etc etc.
I can't seem to nail down what makes it start - I'm not actually
using the system at present.
I just set it up to do some testing and it's just sitting there idle.
Any suggestions what's going on here or how to troubleshoot further?
Brian
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.7 (Darwin)
Comment: Verify this email or encrypt your email for free - see gnupg.org
iD8DBQFHl6srGnOmb9xIQHQRAujRAJ9f2VUlfGMP7OUbz8fqSn2bii9BxQCg1TeG
TG38UsibefkhPgMWUi1hbUM=
=A2pV
-----END PGP SIGNATURE-----
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
