Oscar Corte wrote:
Hi all I’m using Debian Etch, and in order to activate my network card y have
to go into “Networking” gnome’s option menu, click on eth0, then click on
“Deactivate” button and then on “Activate”. I don't get an IP address unless I
do this. There should be a configuration where this can be fixed, however I’m
not sure which one. After reading some other topics into this list I assume
that this should be into '/etc/network/interfaces'. Is this correct? I would
appreciate any hints about it or any links to documentation where I can find
more about this. Thanks to everyone and Regards.
Oscar Corte
_________________________________________________________________
Chapter 10 of the debian reference manual describes the procedure to
configure networking.
http://www.debian.org/doc/manuals/reference/ch-gateway.en.html
You might find it easier to use the gui tool "network-admin" to set your
preferences. Select eth0 and click on the "Properties" button to make
your changes.
HTH,
rajkiran
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
