Robert Cates pisze: >> > Thanks for the tip/info. My dmesg shows: > > SCSI subsystem initialized > Initializing USB Mass Storage driver... > scsi0 : SCSI emulation for USB Mass Storage devices > usbcore: registered new driver usb-storage > USB Mass Storage support registered. > usb-storage: device found at 2 > usb-storage: waiting for device to settle before scanning > Vendor: Model: MediBase Rev: 1100 > Type: Direct-Access ANSI SCSI revision: 00 > usb-storage: device scan complete > SCSI device sda: 8125440 512-byte hdwr sectors (4160 MB) > sda: Write Protect is off > sda: Mode Sense: 43 00 00 00 > sda: assuming drive cache: write through > SCSI device sda: 8125440 512-byte hdwr sectors (4160 MB) > sda: Write Protect is off > sda: Mode Sense: 43 00 00 00 > sda: assuming drive cache: write through > sda: sda1 > sd 0:0:0:0: Attached scsi removable disk sda > > but unlike yours, it does not say - usb-storage: device scan complete > Now, what's the best way to get this mounted and usable? Should I > install am-utils for example? I've tried various ways of using the > mount command, but I'm not getting it right (mounted). > > Thanks, > Robert > >
#mkdir /media/sda1 #mount -t vfat /dev/sda1 /media/sda1 #df #umount If works: /etc/fstab: /dev/sda1 /media/sda1 vfat user,noauto,umask=0,exec 0 0 -- Maciej Rutecki http://www.maciek.unixy.pl -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
